|
Normal topic
|
Lawn mower
by charper on Mon, 2018-12-03 14:25 |
General discussion |
|
Normal topic
|
Older version of VESC Tool
by Gas_Sn4ke on Fri, 2018-11-30 09:28 |
VESC Tool |
|
Normal topic
|
Connecting ABI encoder to VESC
by Gas_Sn4ke on Mon, 2018-11-26 06:00 |
VESC Tool |
|
Normal topic
|
I need a minor change to my firmware
by cdw3423vesc on Sat, 2018-11-17 00:55 |
VESC Firmware |
|
Normal topic
|
Set and measure RPM - Questions
by Piep on Thu, 2018-11-08 16:10 |
General discussion |
|
Normal topic
|
dual vesc question
by badger1666 on Sun, 2018-10-28 12:59 |
General discussion |
|
Normal topic
|
Position Control with Resolver
by robo_studienarbeit on Tue, 2018-10-16 18:57 |
General discussion |
|
Normal topic
|
vesc 4.12 2,3miliohm shunts firmware help
by artteth on Sat, 2018-10-13 00:42 |
VESC Firmware |
|
Normal topic
|
Help with translating/converting hall sensor values from BLDC to FOC
by theviith on Thu, 2018-10-11 09:47 |
General discussion |
|
Normal topic
|
Maytech VESC 4.10 UART issues
by LogixCraft on Tue, 2018-09-25 03:13 |
Third Party Hardware |
|
Normal topic
|
Maytech VESC keeps startup spinning slowly
by Snorreman on Mon, 2018-09-24 09:57 |
Third Party Hardware |
|
Normal topic
|
FAULT_CODE_DRV Motor not spinning
by Mightyorc on Sat, 2018-09-15 03:36 |
General discussion |
|
Normal topic
|
Maytech esc 5V rail reads 0.5v
by hhhhghg on Fri, 2018-09-14 13:23 |
Third Party Hardware |
|
Normal topic
|
Cut-out at >40A
by thewho on Thu, 2018-09-13 20:24 |
General discussion |
|
Normal topic
|
Prevent Wheel-slip by low-pass filtering duty cycle output
by AlexBenn on Thu, 2018-09-13 07:50 |
VESC Firmware |
|
Normal topic
|
Single shunt
by andreas on Wed, 2018-09-12 22:17 |
Feature Requests |
|
Normal topic
|
Vesc and Arduino Interface with ppm control????
by ruthvikchanda on Mon, 2018-09-10 12:01 |
General discussion |
|
Normal topic
|
Foc openloop soft start
by Alan oldguy on Fri, 2018-09-07 03:05 |
Feature Requests |
|
Normal topic
|
Move FAULT pin to GPIOD_PIN2
by CTSchorsch on Tue, 2018-09-04 10:13 |
VESC Firmware |
|
Normal topic
|
Ramping and idle control
by dougm on Sat, 2018-09-01 16:22 |
Feature Requests |
