|
Normal topic
|
Help setting up dual vesc via CANBUS
by Jaystro16 on Sun, 2019-08-04 01:39 |
VESC Firmware |
|
Normal topic
|
Can I re-use an old Galaxy S3 to run the VESC tool?
by Munkyheed on Fri, 2019-08-02 20:00 |
VESC Tool |
|
Normal topic
|
Programming Vesc 4.12 motor spin only in detection mode
by DanieleRA on Sun, 2019-07-28 16:29 |
VESC Original Hardware |
|
Normal topic
|
VESC with no working brake button
by tavsanist on Sat, 2019-07-27 02:40 |
General discussion |
|
Normal topic
|
Weird BLDC Current Waveform
by thepcman on Thu, 2019-07-25 10:38 |
General discussion |
|
Normal topic
|
Current loop resonance in higher ERPM under Current Mode
by ypl on Sat, 2019-07-20 09:34 |
General discussion |
|
Normal topic
|
Reassign status LED ports
by Filcas on Fri, 2019-07-19 17:17 |
VESC Firmware |
|
Normal topic
|
Serial Communication in Non-RT System
by Jack_Li on Fri, 2019-07-05 15:58 |
VESC Firmware |
|
Normal topic
|
How to Write Serial Communication Program Not Applicable to RTOS
by Jack_Li on Fri, 2019-07-05 06:55 |
General discussion |
|
Normal topic
|
step by step ebike thorttle setup
by sindre on Wed, 2019-07-03 17:59 |
General discussion |
|
Normal topic
|
dual VESC battery current
by chris_winkel on Tue, 2019-06-18 15:26 |
VESC Original Hardware |
|
Normal topic
|
Step/Dir signals
by wall0069 on Sun, 2019-06-09 16:06 |
General discussion |
|
Normal topic
|
Dual control loop with magnetic encoders
by wall0069 on Sun, 2019-06-02 05:39 |
Feature Requests |
|
Normal topic
|
UART write read arduino
by matiller on Sat, 2019-06-01 20:18 |
VESC Tool |
|
Normal topic
|
ADC Positive and Negative Ramping Time - not working
by Astropower on Tue, 2019-05-28 22:41 |
VESC Tool |
|
Normal topic
|
Fault: FAULT_CODE_HIGH_OFFSET_CURRENT_SENSOR_3 on VESC 6
by Jackl on Tue, 2019-05-28 14:48 |
VESC Original Hardware |
|
Normal topic
|
Servomotor control with VESC6
by Humberto Estrada on Wed, 2019-05-22 16:15 |
VESC Original Hardware |
|
Normal topic
|
FOC Detection works but BLDC detection fails
by gv260ea on Sun, 2019-05-19 04:15 |
General discussion |
|
Normal topic
|
Is COMM_GET_VALUES working on 3.56 fw 410 ?
by cnd on Tue, 2019-05-14 17:10 |
VESC Firmware |
|
Normal topic
|
Using Motor hall sensors as the encoder
by Russ g on Wed, 2019-05-08 16:01 |
General discussion |
