|
Normal topic
|
Vesc tool app not installed on Samsung a02s
by Zuky on Sun, 2025-08-03 20:31 |
VESC Tool |
|
Normal topic
|
FOC Flux Linkage Detection
by SebastianBa28 on Fri, 2025-08-01 19:10 |
VESC Tool |
|
Normal topic
|
Sleep mode?
by pcace on Wed, 2025-07-30 06:48 |
General discussion |
|
Normal topic
|
Motor runs heavy in one direction, light in the other / No speed in realtime interface / Correct phase & hall wiring?
by pcace on Sat, 2025-07-26 08:00 |
General discussion |
|
Normal topic
|
firmware w/ no hw limits
by dewcantoo on Sat, 2025-07-19 21:10 |
VESC Firmware |
|
Normal topic
|
Kaabo mantis 10 elite(minimotors) FLIPSJY 75100 DUAL ALU PCB
by Musik117 on Fri, 2025-07-18 14:33 |
General discussion |
|
Normal topic
|
VESC Replacing Shunt Resistor with Hall Current Sensor？
by happy85 on Fri, 2025-07-18 06:21 |
General discussion |
|
Normal topic
|
Could use some help tuning for low speed
by Berrie on Tue, 2025-07-15 20:24 |
General discussion |
|
Normal topic
|
Doubts on ERPM limit on VESC 4.12 HW
by raghuvir on Tue, 2025-07-08 13:10 |
VESC Original Hardware |
|
Normal topic
|
VESC 75/300 repair
by mah on Tue, 2025-07-01 16:16 |
VESC Original Hardware |
|
Normal topic
|
Connecting VESC (FSESC75200) to Flight Controller (Matek H743) for Rover — Setup and Recommendations
by ispor4en on Fri, 2025-06-27 21:36 |
Projects incorporating VESC technology |
|
Normal topic
|
Switch between pre-defined profiles over UART
by PutridFox on Sun, 2025-06-15 13:11 |
General discussion |
|
Normal topic
|
Innotrace X1 motor controller for Bafang m620 UART with VESC firmware
by TPEHAK on Tue, 2025-06-10 22:00 |
VESC Firmware |
|
Normal topic
|
Flipsky 75100 V2 with Maxon 386675
by GoFast99 on Thu, 2025-06-05 20:54 |
Third Party Hardware |
|
Normal topic
|
base on VESC6_MkVI
by gavin on Wed, 2025-06-04 15:48 |
General discussion |
|
Normal topic
|
Throttle cutout or no response...MK6 + CA3 + Older Stand alone shunt
by craigoroszi on Tue, 2025-06-03 05:24 |
Third Party Hardware |
|
Normal topic
|
Flipsky and Trampa getting two very different detected resistances on same motor!
by colmor on Wed, 2025-05-28 22:52 |
General discussion |
|
Normal topic
|
Reversed polarity on one of my controllers when setting up
by jsherbz92 on Sun, 2025-05-25 15:16 |
General discussion |
|
Normal topic
|
tuning low kv high pole sensorless outrunner
by cdlapoin on Tue, 2025-05-20 22:14 |
General discussion |
|
Normal topic
|
Cruise control
by palaga on Tue, 2025-05-20 09:20 |
General discussion |
