You are here
Active forum topics
Primary tabs
| Topic | Replies |
Last post |
Forum | |
|---|---|---|---|---|
|
(Open source) BMS by soltesz on Mon, 2017-12-18 00:26 |
2 |
by Pimousse Mon, 2018-01-08 16:26 |
Third Party Hardware | |
|
Calculation of Current and Voltage by Christian on Tue, 2017-12-12 10:12 |
5 |
by Roger Wolff Sun, 2018-01-07 15:41 |
VESC Firmware | |
|
vesc from flier by Doublewave on Sat, 2017-12-30 10:15 |
1 |
by josh Thu, 2018-01-04 04:32 |
VESC Original Hardware | |
|
Motor rotation direction by e-biker on Fri, 2017-12-22 15:02 |
2 |
by e-biker Tue, 2018-01-02 13:15 |
General discussion | |
|
Bug: Tachometer does not change when handbrake is turned on by wdaehn on Mon, 2017-12-25 10:12 |
by wdaehn Mon, 2017-12-25 10:12 |
VESC Firmware | ||
|
Positional Control, Hall Sensor by wdaehn on Fri, 2017-12-08 15:02 |
4 |
by wdaehn Mon, 2017-12-25 09:46 |
General discussion | |
|
Merry Christmas! by frank on Fri, 2017-12-22 14:31 |
4 |
by ThierryGTLTS Sun, 2017-12-24 14:34 |
General discussion | |
|
Motor detection failed/ 0 faults by jnweb29 on Sat, 2017-12-23 21:07 |
by jnweb29 Sat, 2017-12-23 21:07 |
VESC Tool | ||
|
VESC 6.0 Hardware Shows Up As HW 410 in VESC-Tool by FWachter on Thu, 2017-12-21 20:51 |
1 |
by wdaehn Fri, 2017-12-22 08:22 |
VESC Firmware | |
|
Flux linkage observer @ low speed by soltesz on Sun, 2017-12-17 16:33 |
9 |
by benjamin Thu, 2017-12-21 10:17 |
VESC Firmware | |
|
VESC hardware schematics by cromoly on Tue, 2017-11-28 04:44 |
4 |
by ThierryGTLTS Tue, 2017-12-19 14:03 |
VESC Original Hardware | |
|
Motor shaft machining advices are welcome! by ThierryGTLTS on Tue, 2017-11-14 17:40 |
5 |
by William Yates Mon, 2017-12-18 18:22 |
The VESC-Project | |
|
Two Motors on same Shaft by Giga93 on Thu, 2017-12-14 10:12 |
5 |
by ThierryGTLTS Sun, 2017-12-17 13:20 |
General discussion | |
|
[Contributing][FOC] injected ADC and code clarity by Guillaume227 on Fri, 2017-12-15 18:00 |
1 |
by Roger Wolff Sat, 2017-12-16 13:21 |
VESC Firmware | |
|
trampa by badger1666 on Mon, 2017-12-11 22:37 |
5 |
by wdaehn Wed, 2017-12-13 12:17 |
General discussion | |
|
MOSFET driver delay compensation by e-biker on Sun, 2017-12-10 16:21 |
2 |
by e-biker Tue, 2017-12-12 09:41 |
General discussion | |
|
Driving the FETs.... by Roger Wolff on Sat, 2017-10-21 16:37 |
17 |
by Roger Wolff Mon, 2017-12-11 20:55 |
Third Party Hardware | |
|
Minimum speed by Davideo on Sat, 2017-10-21 17:40 |
7 |
by Davideo Thu, 2017-12-07 00:18 |
General discussion | |
|
Hub Motor Remote Control by bf01 on Tue, 2017-11-14 16:04 |
3 |
by frank Wed, 2017-12-06 23:41 |
General discussion | |
|
bugreport. Scale useless by Roger Wolff on Wed, 2017-11-29 12:24 |
1 |
by Svenska Svenson Mon, 2017-12-04 07:56 |
VESC Tool |
Pages
