General discussion

Hello!

It would nice to have native system for PAS+UART for both pedelec and bt-module, then one could get a really clean setup for e-bike

but for now I would like to know how to make PAS work with Bt-module. i did notice couple posts about it. But I don't know how to do it..basically how to get to hwconf to change PAS pins from uart to adc

could someone teach rookie, how to code in vesc

Here is some info about it

Hello. 

Hi there.

I have some experience with BLDC motors, but this is my first time with a ESC Mini FSESC4.20, connected to a sensorless BM400 V3 2845/09 2100KV - INRUNNER MOTOR. 

I have it connected to the VESC Tool software and I can read and write to the drive, no problem.

I my application (a type of eboard), I need a very slow (high torque) start to the motor, and the ability to ramp up slowly to a speed set by the user.

Hiya guys,

I know this has been previously discussed but I have tried and tried with no luck.

New markerbase 75200 x 2 connected via can and with bt dongle.

When I first posted on Bluetooth connection worked and I was able to setup motors. A few minutes later it disconnected and when trying to reconnect I get the error message in the subject line.

I have since tried another dongle giving the same issue. Have also tried changing the rx and tz overawed seen in other comments but still no luck.

Ok so I have a 60v 40 amp hour battery, Vesc controller, and my1020 motor. 
Either way this setup should be able to push 3000 watts nominal, or 6000 watts peak. Or at least close to. 
 

however my question is, I've adjusted a bunch of parameters and my bike is super slow maybe 20 mph and not even hardly torquey for that speed. 
 

Hi everyone. I am building a 3 phase High Voltage ESC based in the HW4.1. I already build the hardware and tested it with another code I wrote for a 3 pahse Dual Active Bridge. All the stages of the power converted work as intended: power, gate driver and controller.

Now I want to use the VESC tool to control a High voltage motor: 800 volts.

I have a cl700 and I am trying to hook up regen braking. I am using a thumb throttle for my regen and it has 3 wires. The harness off the cl700 says to use the same plug as the throttle. So do I just splice the 2 reds and the 2 black wires together and put the 3rd wire directly into the plug? I just don't want to do this wrong. My last question is the aux power plug. I don't have any voltage across the pins. Do I need to turn on the aux power somewhere?

Hi All,

I have my own version of Vesc6 with same components of Trampa Version, different layout.

It work like a charm with an 8 pole 500W inrunner at 48V , perfect current readings, smooth start etc

I tried to run a 100W  outrunner motor ( https://www.faulhaber.com/en/products/series/3216bxtr/ ) at 24V with orrible results.

The resistence measure are ok and coherent with the datasheet, it correctly measure the Lambda and the motor slowly spin as usual .