You are here
Active forum topics
Primary tabs
Topic | Replies | Last post | Forum | |
---|---|---|---|---|
75/300 R3 with Original FW 4.2 can't update by nice2cu on Sun, 2020-06-14 17:26 |
1 |
by nice2cu Mon, 2020-06-15 20:41 |
VESC Original Hardware | |
FOC detection needs load? by tuloski on Thu, 2018-09-13 10:19 |
1 |
by TechAUmNu Thu, 2018-09-13 12:26 |
VESC Tool | |
Firmware for Hardware V6 by EU-Sampler on Fri, 2018-08-31 08:50 |
1 |
by Danny Bokma Fri, 2018-08-31 13:16 |
VESC Firmware | |
VESC clone smoked - help needed please by JoshuaGraham14 on Fri, 2020-09-11 00:14 |
1 |
by TheFallen Tue, 2020-09-22 10:34 |
Third Party Hardware | |
48V Battery cuts off while doing Motor Wizard by NiZZioN on Sun, 2022-04-24 15:31 |
1 |
by kexbox Fri, 2022-05-06 16:32 |
Third Party Hardware | |
High rpm issue kde3520xf by magnus.w on Fri, 2019-04-26 12:46 |
1 |
by magnus.w Sat, 2019-05-04 12:33 |
General discussion | |
VESC tool firmware of 256KBytes by Arthur00 on Sat, 2022-12-03 20:57 |
1 |
by skyline1970 Sun, 2022-12-04 13:28 |
VESC Firmware | |
Axiom: 100+kW controller by paltatech on Sat, 2019-04-13 17:09 |
1 |
by thewho Sun, 2019-04-14 00:48 |
Third Party Hardware | |
Changing Capacitors by Jreamer on Wed, 2017-10-25 08:54 |
1 |
by ThierryGTLTS Wed, 2017-10-25 09:25 |
Third Party Hardware | |
VESC on an STM32F4 Discovery board by sonnbc on Tue, 2020-10-06 06:55 |
1 |
by selenakale Thu, 2020-10-22 04:40 |
General discussion | |
Powering a Beckhoff AM3100 Synchronus Servomotor with FOC by Michael Hamm on Mon, 2022-01-24 10:42 |
1 |
by frank Mon, 2022-01-24 12:36 |
General discussion | |
anybody interested in ninebot-segway's sensorless position observer? by lanmanck on Mon, 2020-06-01 04:33 |
1 |
by lanmanck Wed, 2020-06-03 02:57 |
General discussion | |
Limiting of throttle curves has no effect by Ackmaniac on Thu, 2017-09-07 17:21 |
1 |
by frank Tue, 2017-09-19 09:35 |
VESC Firmware | |
Question to get a new Motor Running by speedy on Fri, 2018-07-20 07:59 |
1 |
by frank Fri, 2018-07-20 10:23 |
General discussion | |
Strange behaviour when controlling RPM by MrMonk3y on Wed, 2019-05-08 14:29 |
1 |
by cnd Mon, 2019-05-27 08:41 |
General discussion | |
Controlled decend speed on long downhill by sjgan68 on Sun, 2020-08-09 11:38 |
1 |
by vadicus Sun, 2020-08-09 20:49 |
General discussion | |
Vesc 6 MKIV Power Switch by KitemillAS on Wed, 2021-12-01 19:44 |
1 |
by frank Wed, 2021-12-01 22:04 |
General discussion | |
PID - Position Angle Division by robo_studienarbeit on Tue, 2018-12-04 18:46 |
1 |
by Nellieorton Fri, 2019-09-20 06:49 |
VESC Firmware | |
Custom Display Receiver for VESC by WatEvsCevs on Wed, 2019-08-28 02:29 |
1 |
by frank Fri, 2019-08-30 10:03 |
General discussion | |
Can not run again after run perfectly !! Pls help by Streetstar69 on Tue, 2021-11-23 03:03 |
1 |
by frank Tue, 2021-11-23 10:03 |
General discussion |