You are here
Active forum topics
Primary tabs
| Topic |
Replies |
Last post | Forum | |
|---|---|---|---|---|
|
Dutycyle dropping under load by Julzz112 on Sun, 2024-04-14 18:31 |
by Julzz112 Tue, 2024-04-16 08:26 |
General discussion | ||
|
Need Help Setting Up Dual VESC on Trampa by MIKEtheBIKE on Wed, 2020-09-09 03:15 |
by MIKEtheBIKE Wed, 2020-09-09 03:15 |
VESC Tool | ||
|
Connection/power problem by PredatorRTX on Fri, 2024-03-29 10:43 |
by PredatorRTX Fri, 2024-03-29 10:43 |
General discussion | ||
|
Hi by elsie on Thu, 2018-01-25 02:49 |
by elsie Thu, 2018-01-25 16:23 |
General discussion | ||
|
12v(3s) Input to VESC 75/250 by AliBarrett10 on Wed, 2021-03-24 14:36 |
by AliBarrett10 Wed, 2021-03-24 16:19 |
General discussion | ||
|
Tenka esc in need of a reliable vesc tool by Vincent Gervais on Tue, 2021-12-21 00:48 |
by Vincent Gervais Tue, 2021-12-21 00:48 |
Third Party Hardware | ||
|
Tips on tuning PID for a 170mm RW170 hub motor, 15 pole-pairs, low speed, high torque, 0-3000 ERPM by PaulMakesThings on Fri, 2022-08-05 11:06 |
by PaulMakesThings Fri, 2022-08-05 11:06 |
General discussion | ||
|
Settings by aquamarin on Sat, 2023-07-01 16:11 |
by aquamarin Sat, 2023-07-01 16:11 |
General discussion | ||
|
Steering channel (dual vesc setup via CAN bus) by fender90 on Sun, 2020-04-26 03:47 |
by fender90 Sun, 2020-04-26 03:47 |
Feature Requests | ||
|
controller_id on COMM_GET_IMU_DATA by andrea.scipione on Sun, 2020-11-22 19:07 |
by andrea.scipione Sun, 2020-11-22 19:07 |
Feature Requests | ||
|
Ground Loop question by a.smith on Wed, 2021-06-23 13:25 |
by a.smith Wed, 2021-06-23 13:25 |
General discussion | ||
|
Need IRF7759 by marcel7162 on Fri, 2022-03-18 22:29 |
by marcel7162 Fri, 2022-03-18 22:29 |
Third Party Hardware | ||
|
Bricked my VESC six what now? by atat on Sun, 2018-05-20 13:07 |
by atat Sun, 2018-05-20 14:28 |
General discussion | ||
|
Rion Tronic 250/ Focer3.1 using TC leads to explosion! by Drcfan on Mon, 2022-11-14 23:12 |
by Drcfan Tue, 2022-11-15 14:05 |
General discussion | ||
|
VESC BMS Charger Disengaging early by sandersesurf on Tue, 2024-01-09 13:56 |
by sandersesurf Tue, 2024-01-09 13:56 |
General discussion | ||
|
Porting VESC to STML4 by Vince_1618 on Fri, 2022-10-28 14:01 |
by Vince_1618 Fri, 2022-10-28 14:01 |
General discussion | ||
|
VESC 6 Mark III and Traxxas Summit Radio Receiver PWM / PPM Signals by j98221@gmail.com on Fri, 2020-07-03 07:27 |
by j98221@gmail.com Fri, 2020-07-03 07:27 |
General discussion | ||
|
PWM connection for a remote by dsuresh on Fri, 2021-02-19 19:17 |
by dsuresh Fri, 2021-02-19 19:17 |
General discussion | ||
|
Help with translating/converting hall sensor values from BLDC to FOC by theviith on Thu, 2018-10-11 09:47 |
by theviith Thu, 2018-10-11 09:47 |
General discussion | ||
|
PID Speed Control code....for NRF by Dimitri on Tue, 2017-10-03 07:16 |
by Dimitri Tue, 2017-10-03 07:18 |
VESC Firmware |
Pages
