You are here
Active forum topics
Primary tabs
Topic |
Replies | Last post | Forum | |
|---|---|---|---|---|
|
200V +200A power stage and custom VESC controller with fault protection by ZombieSS on Sat, 2020-07-18 07:35 |
3 |
by mystamo Tue, 2020-07-28 22:07 |
Third Party Hardware | |
|
22 pole motor and potentiometer throttle by Kenneth on Mon, 2020-04-27 23:01 |
1 |
by Kenneth Tue, 2020-04-28 08:59 |
General discussion | |
|
24v Kobalt Powered Sunjoe Mower by mistersketchman on Sun, 2020-08-02 01:54 |
by mistersketchman Sun, 2020-08-02 01:55 |
Third Party Hardware | ||
|
2nd Maytech 75_300 burned by Flyingtux on Wed, 2022-03-16 22:15 |
1 |
by skyline1970 Fri, 2022-03-25 19:00 |
General discussion | |
|
3 Phase DC Motor and VESC by Mustard on Sun, 2021-05-23 19:03 |
1 |
by skyline1970 Sat, 2021-09-18 11:50 |
General discussion | |
|
3 sensorless motors connected with belt by moose09876 on Wed, 2022-09-14 23:26 |
5 |
by moose09876 Fri, 2022-09-16 14:09 |
General discussion | |
|
3 shunt low side resistor configuration based on VESC 6 by jordanlow on Thu, 2019-02-14 16:42 |
1 |
by TechAUmNu Thu, 2019-02-14 18:31 |
Third Party Hardware | |
|
3 shunt low side vs 3 shunt 'in phase' current sensing by ripperpc on Mon, 2020-05-04 08:47 |
6 |
by bww129 Wed, 2020-05-27 17:59 |
General discussion | |
|
3 speed switch by de-bodgery on Sat, 2021-08-21 02:22 |
17 |
by Oscar Lozano Gimenez Mon, 2023-05-22 14:07 |
General discussion | |
|
3.3v short. is repair possible? by TZTZ on Sat, 2021-08-21 10:33 |
4 |
by tecnico.solarboat Mon, 2021-12-27 23:31 |
VESC Original Hardware | |
|
3.3V/5V External Electronics Raspberry Pi by ed muthiah on Sun, 2020-07-19 16:38 |
1 |
by TheFallen Mon, 2020-07-20 15:15 |
General discussion | |
|
3.64 can_scan breaks with ppm enabled. by fessyfoo on Fri, 2019-12-20 20:40 |
1 |
by fessyfoo Sun, 2019-12-22 03:44 |
VESC Firmware | |
|
30kw 34s 144v: WiFi, BLE, iOS support, GPS/LTE Options (Page: 1, 2, 3)
by vadicus on Tue, 2019-12-03 20:29 |
133 |
by NOAI Wed, 2023-10-11 06:37 |
Third Party Hardware | |
|
360 Rotation Hall Sensors, would these work through ADC? by portnawake on Thu, 2018-06-07 02:37 |
3 |
by Roger Wolff Fri, 2018-06-15 08:50 |
General discussion | |
|
3rd harmonic injection or SVPWM/ Midpoint Clamp for FOC by ufechner on Sat, 2018-04-21 06:05 |
3 |
by arvidb Tue, 2018-05-08 16:35 |
VESC Firmware | |
|
3Shul 700A reporting negative current spikes by reobaird on Sat, 2023-03-25 03:22 |
by reobaird Mon, 2023-03-27 09:34 |
General discussion | ||
|
4 BLDC for 1 VESC by mac_cros on Wed, 2019-03-20 16:45 |
8 |
by tul00985 Wed, 2019-04-03 08:32 |
Third Party Hardware | |
|
4 fried vesc's Australia by adamclarke1985 on Tue, 2020-03-31 20:48 |
by adamclarke1985 Tue, 2020-03-31 21:24 |
General discussion | ||
|
4 vesc motors at once? by i-make-robots on Thu, 2020-04-16 02:17 |
1 |
by hexakopter Sat, 2020-04-18 12:20 |
General discussion | |
|
4.12 cooling mod by thewho on Wed, 2019-05-01 18:45 |
by thewho Wed, 2019-05-01 18:45 |
General discussion |
Pages
