You are here
Active forum topics
Primary tabs
| Topic | Replies |
Last post |
Forum | |
|---|---|---|---|---|
|
Inquiry about Incremental and Absolute Encoders in VESC for Robotics by sivanhere on Fri, 2022-10-28 21:02 |
by sivanhere Fri, 2022-10-28 21:02 |
General discussion | ||
|
Is this kogging and jitter in low rpms expected? by Snabelost on Sat, 2022-10-22 16:53 |
8 |
by Snabelost Fri, 2022-10-28 16:07 |
General discussion | |
|
Porting VESC to STML4 by Vince_1618 on Fri, 2022-10-28 14:01 |
by Vince_1618 Fri, 2022-10-28 14:01 |
General discussion | ||
|
Issue with VESC I/O on donkey car by baluja on Fri, 2022-10-28 02:56 |
by baluja Fri, 2022-10-28 02:56 |
General discussion | ||
|
Writing to slave vesc sometimes cause loss of can bus by meashman on Wed, 2022-07-20 01:08 |
2 |
by frank Thu, 2022-10-27 08:54 |
VESC Tool | |
|
How to use an IMU and a PPM remote parallel by Gos1 on Tue, 2022-10-25 15:28 |
by Gos1 Wed, 2022-10-26 10:57 |
General discussion | ||
|
Aircraft Auxiliary Power Unit starter by Shaftdriver on Mon, 2022-10-10 13:10 |
4 |
by velolac Tue, 2022-10-25 20:38 |
Projects incorporating VESC technology | |
|
Dual motor fishing boat by Snabelost on Mon, 2022-10-17 02:41 |
1 |
by canoeman Tue, 2022-10-25 15:11 |
Projects incorporating VESC technology | |
|
Vesc with ROS over can bus by meilutisr on Fri, 2021-07-09 18:29 |
1 |
by hiqsol Tue, 2022-10-25 14:23 |
General discussion | |
|
Tuning prop loads with rapid erpm increase in duty cycle or speed control by mirage98 on Mon, 2022-09-26 01:51 |
1 |
by drummerboy5408 Mon, 2022-10-24 05:49 |
General discussion | |
|
Electric/ Gas Hybrid by kcswimrac on Wed, 2020-05-06 17:05 |
4 |
by drummerboy5408 Mon, 2022-10-24 05:43 |
General discussion | |
|
Inconsistant braking force when full brake starting to apply by Koxx3 on Sat, 2022-10-22 16:21 |
1 |
by Koxx3 Sun, 2022-10-23 13:22 |
General discussion | |
|
GPIO Pins on VESC? by phils on Sat, 2022-10-22 17:58 |
1 |
by frank Sat, 2022-10-22 20:37 |
General discussion | |
|
Looking for a technical co-founder for a VESC-Based Startup Project by pex on Fri, 2022-10-21 18:35 |
2 |
by pex Sat, 2022-10-22 01:37 |
General discussion | |
|
Undervoltage Fault by gazlinux on Tue, 2022-02-08 02:26 |
3 |
by 67RS427 Fri, 2022-10-21 20:53 |
General discussion | |
|
Encoder connection by Herbie on Fri, 2019-05-31 15:12 |
11 |
by Dencio1976 Fri, 2022-10-21 13:46 |
General discussion | |
|
DRV835x by AdinAck on Thu, 2022-10-20 16:14 |
1 |
by frank Fri, 2022-10-21 13:06 |
VESC Firmware | |
|
Unable to connect to vesc through can bus by Kupofty on Thu, 2022-10-20 16:24 |
by Kupofty Thu, 2022-10-20 16:24 |
VESC Tool | ||
|
Dual motor setup for Turnigy SK8 V2 60A x 2 3~12S Twin Motor Skateboard ESC? by fil02184 on Tue, 2022-10-18 04:07 |
by fil02184 Tue, 2022-10-18 16:00 |
General discussion | ||
|
Request Feature to add minimum Battery Voltage value in addition to duty cycle for field weakening by aquaponiccowboy on Mon, 2022-10-17 04:49 |
by aquaponiccowboy Mon, 2022-10-17 04:50 |
Feature Requests |
Pages
