You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter | Replies |
Last post |
|
|---|---|---|---|
|
Custom Built ESC based on VESC 6.6 by jordanlow » Sun, 2020-05-03 16:07 |
3 |
by regskd Tue, 2020-07-28 23:35 |
|
|
VESC for robot running on Jetson NX, ROS and Neo BLDC motor by gpetilli » Mon, 2020-07-27 22:09 |
1 |
by regskd Tue, 2020-07-28 22:29 |
|
|
Noise related issues? by RDN2003 » Sun, 2020-07-26 20:17 |
0 |
by RDN2003 Sun, 2020-07-26 20:17 |
|
|
VESC 75/300 suited for a 4.5 tonne sailboat? by Henque19 » Wed, 2019-05-22 11:10 |
6 |
by Impuls60 Fri, 2020-07-24 02:02 |
|
|
Making master and slave motors communicate both ways by Sis7 » Tue, 2020-07-21 05:58 |
0 |
by Sis7 Tue, 2020-07-21 05:58 |
|
|
3.3V/5V External Electronics Raspberry Pi by ed muthiah » Sun, 2020-07-19 16:38 |
1 |
by TheFallen Mon, 2020-07-20 15:15 |
|
|
Max eRPM with latest firmware by kubark42 » Fri, 2020-07-17 19:10 |
0 |
by kubark42 Fri, 2020-07-17 19:10 |
|
|
Noised signal from motor NTC sensor | HW4.12 FW3.27 by ma-j-sterelektron » Wed, 2017-09-06 18:41 |
10 |
by vescsci Wed, 2020-07-15 22:47 |
|
|
FOC vs. BLDC by CTSchorsch » Wed, 2020-07-15 13:15 |
0 |
by CTSchorsch Wed, 2020-07-15 13:15 |
|
|
What's wrong with my motors? by Mads7400 » Fri, 2020-05-08 15:05 |
1 |
by tylr_r Wed, 2020-07-15 01:22 |
|
|
New to electric skateboards - Can't seem to get FSESC set up properly by iguanahotsauce » Sun, 2020-07-12 06:11 |
1 |
by transcendStaticMode Tue, 2020-07-14 07:56 |
|
|
Hoverboard Motor with VESC by mados73 » Wed, 2018-03-21 22:14 |
12 |
by Kirkness Mon, 2020-07-13 01:00 |
|
|
Issue connecting to ESC 4.12 by Kirkness » Wed, 2020-07-08 01:40 |
2 |
by TheFallen Thu, 2020-07-09 18:01 |
|
|
Regenerative braking in scooter Zero x11 72V dual motor 2 x 1600 w peak power 6000W by Makroman » Wed, 2020-07-08 20:00 |
0 |
by Makroman Wed, 2020-07-08 20:00 |
|
|
Protect psu from regenerative braking by KarlGreger » Tue, 2020-01-28 03:45 |
4 |
by marc.s.cohn@gma... Tue, 2020-07-07 21:11 |
|
|
ADC input protection proposal by arestechfinland » Mon, 2020-07-06 19:41 |
0 |
by arestechfinland Mon, 2020-07-06 19:41 |
|
|
Regen Braking / Braking Current under Different Voltages by kimjungyeop » Tue, 2020-02-25 23:47 |
2 |
by Makroman Mon, 2020-07-06 11:58 |
|
|
Using VESC to drive sensorless linear motor to simulate on/off solenoid by cmcraeslo » Wed, 2020-07-01 09:15 |
1 |
by pf26 Mon, 2020-07-06 11:10 |
|
|
Regen braking not working? by forcefed » Thu, 2018-04-05 01:57 |
3 |
by Makroman Sun, 2020-07-05 16:12 |
|
|
VESC 6 Mark III and Traxxas Summit Radio Receiver PWM / PPM Signals by j98221@gmail.com » Fri, 2020-07-03 07:27 |
0 |
by j98221@gmail.com Fri, 2020-07-03 07:27 |
|
|
simulate turboprop engine ... using VESC, how to.... by Eckehard » Wed, 2020-06-10 22:32 |
17 |
by Eckehard Thu, 2020-07-02 22:34 |
|
|
Runaway Motor with No BLE by Marctwo » Thu, 2020-07-02 20:47 |
0 |
by Marctwo Thu, 2020-07-02 20:47 |
|
|
connecting vesc tool with Prototipo by Govert » Thu, 2020-07-02 19:43 |
0 |
by Govert Thu, 2020-07-02 19:43 |
|
|
Requesting fault codes over UART by spork » Wed, 2020-06-24 09:02 |
1 |
by Pimousse Wed, 2020-07-01 12:50 |
|
|
Optimizing VESC6 setup for my Giant Lego Go-Kart project by mantisrobot » Thu, 2020-06-18 13:29 |
3 |
by TechAUmNu Mon, 2020-06-29 10:19 |
Log in to post new content in the forum.
