You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
Help needed in controlling multiple VESC boards (multiple motors) with VESC ROS (need to debug errors) by shreyas.srinivasan » Thu, 2022-10-13 08:13 |
0 |
by shreyas.srinivasan Thu, 2022-10-13 08:13 |
|
|
VESC 6 EDU: Motor Wizard - Detection failed by Navigator_PJE » Mon, 2022-08-29 16:12 |
0 |
by Navigator_PJE Mon, 2022-08-29 16:12 |
|
|
Encoder maximum PPR/CPR by Michelle90 » Mon, 2022-09-05 22:16 |
0 |
by Michelle90 Mon, 2022-09-05 22:16 |
|
|
How to use an IMU and a PPM remote parallel by Gos1 » Tue, 2022-10-25 15:28 |
0 |
by Gos1 Wed, 2022-10-26 10:57 |
|
|
Maximize startup torque by arosenthal » Sat, 2020-11-14 14:16 |
0 |
by arosenthal Sat, 2020-11-14 14:17 |
|
|
Cannot connect to VESC via USB or SWD by hagis » Wed, 2020-09-23 17:21 |
0 |
by hagis Wed, 2020-09-23 17:21 |
|
|
Issue with VESC I/O on donkey car by baluja » Fri, 2022-10-28 02:56 |
0 |
by baluja Fri, 2022-10-28 02:56 |
|
|
Inquiry about Incremental and Absolute Encoders in VESC for Robotics by sivanhere » Fri, 2022-10-28 21:02 |
0 |
by sivanhere Fri, 2022-10-28 21:02 |
|
|
Voltage spikes on BEMF scope by Sgw32 » Wed, 2020-11-18 16:03 |
0 |
by Sgw32 Wed, 2020-11-18 16:06 |
|
|
Hub motor FOC detection. by Roger Wolff » Tue, 2018-08-21 19:12 |
0 |
by Roger Wolff Tue, 2018-08-21 19:12 |
|
|
What do i need? by Robert Thomas » Fri, 2022-09-16 21:39 |
0 |
by Robert Thomas Fri, 2022-09-16 22:12 |
|
|
Does PLL measure the REAL motor speed by wyk » Mon, 2020-11-23 08:34 |
0 |
by wyk Mon, 2020-11-23 08:34 |
|
|
Vesc and Arduino Interface with ppm control???? by ruthvikchanda » Mon, 2018-09-10 12:01 |
0 |
by ruthvikchanda Mon, 2018-09-10 12:01 |
|
|
HFI Tuning - "Start Voltage" Question by drummerboy5408 » Sat, 2022-11-12 03:12 |
0 |
by drummerboy5408 Sat, 2022-11-12 03:12 |
|
|
FAULT_CODE_DRV Motor not spinning by Mightyorc » Sat, 2018-09-15 03:36 |
0 |
by Mightyorc Sat, 2018-09-15 03:36 |
|
|
Rion Tronic 250/ Focer3.1 using TC leads to explosion! by Drcfan » Mon, 2022-11-14 23:12 |
0 |
by Drcfan Tue, 2022-11-15 14:05 |
|
|
VESC packet fram-size by Yosh101 » Fri, 2022-09-30 15:34 |
0 |
by Yosh101 Fri, 2022-09-30 15:34 |
|
|
Install VESC on ubuntu 18.04 bionic by rest_vesc_001 » Tue, 2020-12-08 15:34 |
0 |
by rest_vesc_001 Tue, 2020-12-08 15:34 |
|
|
starting current/torque with speed controller by nomada » Thu, 2023-11-30 12:20 |
0 |
by nomada Thu, 2023-11-30 12:20 |
|
|
Roll to start by Oded Mazor » Sat, 2023-08-05 11:20 |
0 |
by Oded Mazor Sat, 2023-08-05 11:22 |
|
|
Direct drive wheel ac servo+vesc by adilrepas » Wed, 2021-05-26 12:50 |
0 |
by adilrepas Wed, 2021-05-26 12:58 |
|
|
NEW HARDWARE RELEASED!!! | DF_ESC Electric Motor Controller | YouTube Series Walkthrough by d.fresu » Mon, 2023-08-14 18:29 |
0 |
by d.fresu Mon, 2023-08-14 18:29 |
|
|
VESC PAS sensor connection, which pins? by matajumotors » Fri, 2021-05-28 12:37 |
0 |
by matajumotors Fri, 2021-05-28 12:37 |
|
|
Flipsky Mini FSESC 6.7 Pro Red LED flashes every two seconds by never » Sun, 2023-12-17 08:59 |
0 |
by never Sun, 2023-12-17 08:59 |
|
|
Is this current reading normal? by AliBarrett10 » Sat, 2021-07-17 12:59 |
0 |
by AliBarrett10 Sat, 2021-07-17 12:59 |
Log in to post new content in the forum.
