You are here
Active forum topics
Primary tabs
Topic | Replies | Last post | Forum | |
---|---|---|---|---|
E-Bike Throttle connect with Regenerative Braking by E-Toxx on Sat, 2017-09-09 09:38 |
4 |
by Jacki Villis Thu, 2019-05-16 14:43 |
General discussion | |
Trampa VESC6 USB connectivity problem caused by usb hub? by hagoston on Tue, 2021-06-01 10:27 |
4 |
by hagoston Wed, 2021-06-02 09:27 |
General discussion | |
Hooking up two or more motor drivers to the same MCU by darkclaude on Thu, 2019-06-20 10:02 |
4 |
by skyline1970 Wed, 2019-07-31 13:53 |
Third Party Hardware | |
Firmware update thru UART? by cromoly on Tue, 2018-04-17 01:19 |
4 |
by cromoly Fri, 2018-04-20 19:22 |
General discussion | |
No USB with latest VESC FW on 4.12 hardware by chris1seto on Thu, 2019-04-04 04:01 |
4 |
by dp Wed, 2020-12-02 13:01 |
VESC Firmware | |
PPM: Full Duty-Cycle at approx. 15% Throttle by el micha on Thu, 2017-08-10 11:11 |
4 |
by frank Wed, 2021-07-28 12:10 |
VESC6 Beta | |
Set RPM - reverse direction over CAN-Bus by 65273 on Tue, 2022-03-29 14:49 |
4 |
by 65273 Fri, 2022-04-01 15:53 |
General discussion | |
Hall sensor not working by Stupidspencer on Sat, 2019-12-28 20:29 |
4 |
by BeliaEllet Wed, 2021-03-31 17:55 |
VESC Original Hardware | |
Trapezoidal Trajectory/Position Control by wewa on Sun, 2018-09-23 11:33 |
4 |
by ncbanse Thu, 2023-04-20 21:26 |
Feature Requests | |
Reverse button configuration by ElectroToshka on Thu, 2022-06-23 11:09 |
4 |
by frank Fri, 2022-06-24 10:42 |
Third Party Hardware | |
BLDC vs FOC mode, motor‘s spin direction is invert by moto_guy on Wed, 2019-02-20 11:48 |
4 |
by moto_guy Sun, 2019-02-24 09:11 |
General discussion | |
DRV8301 Gate Drive value in Control Register by shaman on Thu, 2019-10-17 04:22 |
4 |
by Rovimo Thu, 2021-01-28 11:14 |
VESC Firmware | |
FOC VESC for QS Motor 205 50H 3000w by karlisakis on Mon, 2021-06-07 21:29 |
4 |
by vadicus Mon, 2021-10-25 19:39 |
General discussion | |
Two phase modulation by jguy on Sat, 2023-12-09 13:33 |
4 |
by jguy Fri, 2023-12-15 11:49 |
General discussion | |
Custom VESC4.8 short circuit error by b4zz on Mon, 2018-12-17 10:26 |
4 |
by b4zz Wed, 2018-12-19 16:48 |
Third Party Hardware | |
One trasmitter two receivers by vikiki on Wed, 2021-11-17 20:40 |
4 |
by Johnvoss Fri, 2021-12-24 03:57 |
VESC Tool | |
Back EMF or motor voltage back to the supply by bdesvaux on Tue, 2022-09-27 09:22 |
4 |
by bdesvaux Wed, 2022-09-28 15:52 |
General discussion | |
Can motor parameters be detected with shaft load? by powerlabor001 on Thu, 2018-03-15 13:24 |
4 |
by powerlabor001 Sat, 2018-03-24 03:07 |
General discussion | |
Vesc firmware update by ron18923 on Sun, 2019-06-16 18:29 |
4 |
by MollyEskam Thu, 2020-07-02 16:49 |
VESC Firmware | |
Max Rpm sensorless BLDC by edwink89 on Mon, 2021-03-29 00:15 |
4 |
by CTSchorsch Tue, 2021-03-30 07:12 |
General discussion |