You are here
Active forum topics
Primary tabs
| Topic | Replies |
Last post |
Forum | |
|---|---|---|---|---|
|
Issue connecting to Flipsky VESC with mobile app (Firmware 6.0.6) by Gabifat on Mon, 2025-12-15 08:35 |
by Gabifat Mon, 2025-12-15 08:35 |
General discussion | ||
|
tuning low kv high pole sensorless outrunner by cdlapoin on Tue, 2025-05-20 22:14 |
3 |
by flagoworld Wed, 2025-12-10 19:29 |
General discussion | |
|
Motor "sticks" and stops spinning by flagoworld on Fri, 2025-12-05 19:03 |
by flagoworld Fri, 2025-12-05 19:03 |
General discussion | ||
|
Running motors under 900ERPM in speed control by Chieflouis01 on Thu, 2025-11-27 21:32 |
2 |
by Chieflouis01 Thu, 2025-11-27 21:33 |
General discussion | |
|
Motor stopped and I had to run Setup Motors FOC wizard to get it going again by JasonBear on Fri, 2025-11-14 13:24 |
2 |
by JasonBear Sun, 2025-11-16 20:41 |
General discussion | |
|
FOC detection. by Roger Wolff on Tue, 2025-10-21 19:57 |
1 |
by tobiokanobi Sat, 2025-11-15 21:02 |
General discussion | |
|
Vesc Orientation Python by flomai28 on Mon, 2025-11-10 09:44 |
by flomai28 Mon, 2025-11-10 09:44 |
General discussion | ||
|
wont gonnect by rustman01 on Wed, 2025-11-05 19:26 |
by rustman01 Wed, 2025-11-05 19:26 |
General discussion | ||
|
VESC to spin motor after power up? by A_Baum92881 on Fri, 2025-10-31 06:01 |
by A_Baum92881 Fri, 2025-10-31 17:21 |
General discussion | ||
|
PAS with variable assist+regen brake by Lukas_T on Fri, 2025-08-29 18:05 |
2 |
by Lukas_T Fri, 2025-10-31 10:28 |
General discussion | |
|
Vesc boost charging with external inductors by Bunda on Wed, 2025-10-29 08:37 |
by Bunda Wed, 2025-10-29 08:38 |
General discussion | ||
|
VESC App - Android - "App not installed" error by KColborne on Mon, 2023-03-27 22:11 |
1 |
by Valopallo Sun, 2025-10-26 14:29 |
General discussion | |
|
vesctool 6.06 for Mac? by gregd72002 on Sat, 2025-09-27 03:36 |
3 |
by electricfox Sat, 2025-10-25 21:34 |
General discussion | |
|
Hall sensor port repeatedly fried on original hardware by Rc 44 on Fri, 2025-10-24 22:44 |
by Rc 44 Fri, 2025-10-24 22:44 |
General discussion | ||
|
Issues with throttle range translating to duty by Elliot Kingsley on Thu, 2025-10-16 02:40 |
1 |
by cwk1234 Tue, 2025-10-21 02:22 |
General discussion | |
|
Charging Li-ion battery using the VESC Harmony 32S BMS by sainihalj on Tue, 2025-10-14 14:42 |
by sainihalj Tue, 2025-10-14 14:42 |
General discussion | ||
|
About How to control the "FLIPSKY Dual FSESC6.7 PLUS" by tonyH on Tue, 2025-10-14 11:35 |
by tonyH Tue, 2025-10-14 11:35 |
General discussion | ||
|
Custom-made VESC PCB: High current sensor offset/Overcurrent fault during motor detection, possible hardware/firmware mismatch by Chinmay Mulgund on Mon, 2025-10-13 13:56 |
by Chinmay Mulgund Mon, 2025-10-13 14:02 |
General discussion | ||
|
VESC OpenLoop for didactic application by dpeinado on Tue, 2022-07-12 12:32 |
3 |
by Alexander470815 Sun, 2025-10-12 18:38 |
General discussion | |
|
FSESC 75350 UNBALANCED_CURRENTS fault at higher loads by colmor on Thu, 2025-05-01 01:21 |
1 |
by erider Thu, 2025-10-09 07:55 |
General discussion |
Pages
