Hi, I am using a Flipsky 75100 (the older version) and I have paired it with a 2800w hub motor. I run the motor detection and setup input, however when ful throttle the motor makes this weird noise like some is hammering it. For the hall sensors I connected them correctly.
Video: video:https://youtube.com/shorts/PxcfiOUOn0I?feature=share
I have an flipsky FSESC4.20 mini (50A), which up until today was working fine. I'm not pushing it too hard, just some bench testing with a 6S setup, 18A max current setting.
During a run (FOC sensored mode, AS5047 via SPI) today, the motor started jumping around rather than running smoothly and drawing the full 18A. I cut power in ~1second.
After that, the FOC mode hasn't worked smoothly.
just seeing if I'm able to post a quick .CSV log to see if anyone can see the issue I'm facing..... thanks
Hi guys, has any one had chance to fix this fsesc. Its mini flipsky 4.12. For some reason it stopped working, i figured tvs diode was blown. Ive change it and it started working but not quite. 3.3v rail is showing 1.7v. Any suggestions ?
I've got this Chinese board and no idea what I'm doing. Can anyone point me in the right direction?
An sdk or anything, not even sure how to communicate with it.
Hi all. Did a search and didn't find anything about this specific issue.
First time setting up an ESC so sadly I don't have a lot of experience under my belt.
For an electric snowboard project, I'm using a Flipsky 75100 with a VX1 remote. It didn't explicitly state anywhere what type of connector it needed, so I guessed VESC4 and it seems like it's the right type? Connects to the COMM wire.
Hi, i'm making VESC 75_300 based 75_150 board with smaller form factor.
It was very hard to just run motor few weeks ago, but after some parameter tuning it can run motor in sensored FOC mode.
I'm testing with T-motor U5 400kv, 6S lipo, AS5047P in Sensored FOC Mode on FW5.03.
BUT I am stuck at some point.
The problem is that when I increase duty over 5% at a time, motor screams and stop running.
Hello,
I've got a 75100 and it works perfect.. until I disconnect it from my computer. When I do, the green light indicating it's receiving a signal from the controller dims, indicating it is not. I have the VESC connected to a microcontroller and can move my motor completely indepedent of anything I do on the computer.
It works fine even when VESC project isn't even open on my computer. But as soon as I unplug it stops working. Any ideas? Thanks.
Hello guys, first post here!
I’m trying to use a Flipsky 75100 and at the beginning everything seemed to be working fine, I was able to detect the motor parameters, the hall sensors, and to spin the motor through the keyboard.
However, when I tried to apply some load, the VESC entered in a reboot mode! I read that it was regarding the 5v 1A BEC!
