Third Party Hardware

Hi,

to introduce myself a bit: As a (soon-to-be open source) hobby project, I want to build a "smart" workout machine with a controller with VESC firmware (the machine uses motors instead of weights to create resistance).
And I have a professional background on PMSM motorcontrol, also with STM32 and even used the AS5047 sensor in the past. Without this background, I'd not even consider such a project...

My flipsky 75100 v2 pro have a problem i cant get data from de 75100 v2 pro from uart and usb i only can send data to vesc from pc and esp32 not read. From bluetooth e can send and read. Hardware problem? Some thing broked? I need uart or usb com for my project. Any help please. Thanks

I am trying to make a custom VESC compatible hardware setup, and I have seen examples of gate drivers from TI's UCC series being used. I have UCC21520 gate drivers and I seem to be confused on how I would go about modifying the source code to be able to work without a DRV chip, as all of the examples with code I can find seem to only use the DRV chips, and looking into the code with my beginner level coding experience makes it seem like there is no option to remove or ignore the DRV communication over SPI.

I have a controller with 5.03 and would like to update it, but the hardware doesn't populate in VESC Tool. 

Is there I way I can read the HW config and make a build for my target?

Thanks,

Hi, I am trying to connect my Bluetooth module to my vesc so I can program it with having to acces it. It is coming up with multiple errors including this hardware version does not have a SWD connection to the NRF5X module. I also got 'The BLE module does not support setup. You can try updating the firmware on it from the swd programmer page'

Any help would be much appreciated.

Thanks. 

Hello everyone,

I'm new to the exciting world of VESC Project. I recently purchased two Flipsky 75200 controllers. I've been playing around with them and managed to get the motors working, but today I discovered how to update the firmware version, as it indicated that there was a new version available.

To my surprise, after updating them, I can no longer set the maximum input voltage beyond 72V, even though I have a 20S battery that reaches 84V.

Does anyone know why this is happening and how to fix it?

Dear All,

Hello All,

Throttle cutout or no response, then after a min or so it re-engages...MK6 + CA3 + Older Grin Stand alone shunt for throttle and display. Could the shunt be failing? It does get warm and i never noticed that before.

Is there any support when your third party goes silent when support is needed?  (Defiant Board)