You are here
Active forum topics
Primary tabs
Topic | Replies | Last post | Forum | |
---|---|---|---|---|
Flipsky motor and flipsky FSESC, can't move when weighted/under load. by adamgil801 on Fri, 2022-07-01 23:17 |
2 |
by Indy8976 Mon, 2022-07-11 11:21 |
General discussion | |
Need help to configure the regenerative brake ... by Loops on Mon, 2019-08-12 19:43 |
2 |
by Loops Wed, 2019-08-14 18:07 |
General discussion | |
Newbie Help please, Longer run time? by Bildoon on Mon, 2020-04-06 02:00 |
1 |
by linsus Thu, 2020-04-16 14:18 |
General discussion | |
Regen wiring Help Pls by Fpvlee on Fri, 2021-06-04 23:44 |
2 |
by frank Sun, 2021-06-06 11:48 |
General discussion | |
How to increase the +/-165A rms current limit to 250A+ rms (350-400A peak) by ev_motors on Sat, 2018-04-28 10:18 |
by ev_motors Sat, 2018-04-28 10:18 |
General discussion | ||
ADC throttle with braking by adobe75 on Thu, 2020-10-29 02:26 |
4 |
by gooki Mon, 2021-12-27 07:07 |
General discussion | |
Difference between ERPM and Duty Cycle by dormanae on Wed, 2022-02-23 17:21 |
1 |
by j.konrad Thu, 2022-02-24 02:08 |
General discussion | |
Input Setup Wizard Does Not Ask if Single or Multi VESC by kylemuramatsu on Wed, 2019-03-13 03:22 |
1 |
by benjamin Wed, 2019-03-13 09:38 |
General discussion | |
Undervoltage Fault by gazlinux on Tue, 2022-02-08 02:26 |
3 |
by 67RS427 Fri, 2022-10-21 20:53 |
General discussion | |
Overcurrent fault when braking by maxhertz on Fri, 2022-10-07 09:38 |
2 |
by maxhertz Sun, 2022-10-09 03:34 |
General discussion | |
75/300 Large inrunner problem (video) by dk-odense on Mon, 2019-11-04 21:53 |
1 |
by frank Tue, 2019-11-05 09:06 |
General discussion | |
VESC Mini 4.20 boots up inconsistently, any suggestions by Djmrozinski on Sat, 2021-02-06 10:54 |
1 |
by skyline1970 Sat, 2021-02-06 19:08 |
General discussion | |
bootloader destroied by notger on Tue, 2017-09-19 19:55 |
3 |
by dinamee Sat, 2018-01-13 10:09 |
General discussion | |
Motor only running in reverse by obex_mike on Mon, 2018-06-25 16:25 |
2 |
by frank Tue, 2018-06-26 12:36 |
General discussion | |
Hello Members! I need suggestions by Scooter Evolution on Mon, 2020-12-07 16:33 |
1 |
by vadicus Tue, 2020-12-08 00:07 |
General discussion | |
Battery/Motor Current on VESC Tool is less than Actuals by gowrav on Thu, 2021-07-15 13:27 |
1 |
by skyline1970 Sat, 2021-09-18 11:44 |
General discussion | |
Set RPM - reverse direction over CAN-Bus by 65273 on Tue, 2022-03-29 14:49 |
4 |
by 65273 Fri, 2022-04-01 15:53 |
General discussion | |
Need help with brushed fc 24 bolt motor control by searth on Sun, 2022-12-18 16:05 |
by searth Sun, 2022-12-18 16:05 |
General discussion | ||
Few questions by ElectroMagneto on Thu, 2020-01-09 23:57 |
10 |
by ElectroMagneto Sat, 2020-01-11 00:45 |
General discussion | |
Cant connect to Flipsky 75100 by Ed222 on Sun, 2022-03-20 00:31 |
3 |
by Ed222 Sun, 2022-03-20 19:01 |
General discussion |