You are here

Feature Requests

Topic / Topic starter Replies Last postsort ascending
Normal topic Hot swapping of controller parameters
by Victor Bruun » Wed, 2020-01-29 09:22
1
by vadicus
Wed, 2020-01-29 20:46
Normal topic Standby - consumption when battery is conencted
by derbe » Thu, 2019-09-26 14:07
4
by frank
Mon, 2020-01-27 20:48
Normal topic ADC Throttle Redundancy
by bgdwiepp » Mon, 2020-01-20 09:18
1
by frank
Mon, 2020-01-27 20:42
Normal topic Filtering of motor temperature readings
by Pedrodemio » Mon, 2019-07-01 22:16
8
by fessyfoo
Sat, 2020-01-11 08:06
Normal topic uROS support
by neuromancer2701 » Wed, 2019-11-06 21:17
0
by neuromancer2701
Wed, 2019-11-06 21:17
Normal topic Bluetooth "ignition key"
by topiaskorpi » Wed, 2019-10-16 18:47
1
by hockinsk
Fri, 2019-11-01 20:14
Normal topic safety switch
by Ralph Luckwaldt » Mon, 2019-10-21 13:15
1
by frank
Mon, 2019-10-21 20:58
Normal topic DC to AC pure-sine inverter mode
by shaman » Fri, 2019-10-18 15:06
0
by shaman
Fri, 2019-10-18 15:06
Normal topic Wand odometer
by hans_maier » Sat, 2019-09-14 15:20
3
by gianni
Mon, 2019-09-23 15:19
Normal topic Ramp time in profiles
by Stupidspencer » Fri, 2019-09-13 20:41
1
by frank
Wed, 2019-09-18 16:46
Hot topic Handbrake when activating brake standstill
by Pimousse » Mon, 2017-09-11 09:50
16
by frank
Wed, 2019-09-18 16:39
Normal topic Read erpm of motor through motor tachometer
by jordanlow » Tue, 2019-04-30 15:18
1
by Teslafly
Sat, 2019-07-20 00:44
Normal topic Trapezoidal Trajectory/Position Control
by wewa » Sun, 2018-09-23 11:33
3
by Ekobot
Fri, 2019-07-12 10:06
Normal topic Dual control loop with magnetic encoders
by wall0069 » Sun, 2019-06-02 05:39
0
by wall0069
Sun, 2019-06-02 05:39
Normal topic ERPM Limit Update Over CAN
by josh » Sun, 2019-06-02 01:48
1
by josh
Sun, 2019-06-02 02:05
Normal topic Support for AMC1301 powered from bootstrap
by antonchromjak » Thu, 2019-04-04 22:46
2
by antonchromjak
Fri, 2019-04-05 11:16
Normal topic Enhance position and rpm control interface / protocol
by brushlessjoe » Wed, 2019-03-20 21:54
0
by brushlessjoe
Wed, 2019-03-20 21:54
Normal topic Motion commands for controlling CNCs
by andresv » Fri, 2017-09-08 10:35
2
by brushlessjoe
Sun, 2019-03-17 21:29
Normal topic Combat Robot Mods
by BrianNave » Sun, 2019-02-24 17:03
0
by BrianNave
Sun, 2019-02-24 17:03
Normal topic Allow braking to override negative ramping time
by Paul15578 » Wed, 2018-01-24 06:20
5
by benjamin
Sat, 2019-02-23 10:14
Normal topic Auto power shut down
by Ecyclist » Thu, 2018-09-20 00:47
4
by sam.vanratt
Sat, 2018-11-24 20:12
Normal topic Vesc slow speed BLDC without coging
by igisboard » Tue, 2018-10-09 18:38
1
by Dillon
Mon, 2018-11-19 01:41
Normal topic Better use of hall sensors.
by ThierryGTLTS » Fri, 2017-10-20 17:18
2
by AfdhalAtiffTan
Wed, 2018-10-24 02:16
Normal topic Show actual encoder RPM
by Enak » Fri, 2017-09-08 01:05
2
by Roger Wolff
Sun, 2018-09-16 09:47
Normal topic Single shunt
by andreas » Wed, 2018-09-12 22:17
0
by andreas
Wed, 2018-09-12 22:17
New posts
No new posts
Hot topic with new posts
Hot topic without new posts
Sticky topic
Locked topic
Subscribe to RSS - Feature Requests