You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
Updating fw by Phill Dixon on Fri, 2018-07-06 19:30 |
1 |
by frank Fri, 2018-07-13 13:19 |
General discussion | |
|
Firmware Update = Quiet Motor? by worldmaverik on Sun, 2020-04-19 21:45 |
by worldmaverik Sun, 2020-04-19 21:45 |
General discussion | ||
|
VESC6 Motor stuttering/shutoff while accelerating by AM3R0 on Wed, 2020-11-18 21:49 |
1 |
by mds1274 Thu, 2020-11-19 01:27 |
General discussion | |
|
PPM duty cycle option not being stored in EEPROM by wjpremerlani on Wed, 2022-06-08 12:49 |
4 |
by frank Thu, 2022-06-09 09:07 |
General discussion | |
|
Dutycyle dropping under load by Julzz112 on Sun, 2024-04-14 18:31 |
by Julzz112 Tue, 2024-04-16 08:26 |
General discussion | ||
|
Dual controller: turn left and right by coolic on Tue, 2025-02-25 13:01 |
1 |
by electricfox Thu, 2025-02-27 07:05 |
General discussion | |
|
LISP_BM and CAN by kinzma on Mon, 2022-07-18 11:28 |
1 |
by kinzma Mon, 2022-07-18 12:46 |
General discussion | |
|
Problem with ADC, with no input voltage is 2.6-3.3 by komar on Fri, 2023-05-26 13:59 |
1 |
by dpeinado Wed, 2023-05-31 09:55 |
General discussion | |
|
Connection/power problem by PredatorRTX on Fri, 2024-03-29 10:43 |
by PredatorRTX Fri, 2024-03-29 10:43 |
General discussion | ||
|
ADC input protection proposal by arestechfinland on Mon, 2020-07-06 19:41 |
by arestechfinland Mon, 2020-07-06 19:41 |
General discussion | ||
|
Is this current reading normal? by AliBarrett10 on Sat, 2021-07-17 12:59 |
by AliBarrett10 Sat, 2021-07-17 12:59 |
General discussion | ||
|
static torque control by wjpremerlani on Sun, 2023-05-14 13:52 |
4 |
by wjpremerlani Sat, 2023-05-20 12:23 |
General discussion | |
|
Interfacing with the VESC using UART by dhruvna on Thu, 2023-03-16 17:42 |
by dhruvna Thu, 2023-03-16 17:42 |
General discussion | ||
|
How is Motor Temperature measured? by shimdidly on Mon, 2017-10-02 07:52 |
4 |
by drummerboy5408 Thu, 2022-05-05 05:06 |
General discussion | |
|
How to Write Serial Communication Program Not Applicable to RTOS by Jack_Li on Fri, 2019-07-05 06:55 |
by Jack_Li Fri, 2019-07-05 06:58 |
General discussion | ||
|
PPM Signal not recognized by nopf on Mon, 2024-06-17 15:31 |
8 |
by nopf Tue, 2024-07-02 15:01 |
General discussion | |
|
Current measurement by Toto on Sun, 2021-02-07 09:12 |
1 |
by skyline1970 Tue, 2021-02-09 19:40 |
General discussion | |
|
VESC 100/250 Voltage spikes? by LondonNight on Mon, 2022-09-05 08:21 |
2 |
by LondonNight Fri, 2022-09-09 18:01 |
General discussion | |
|
Noise with Hall sensor at high speed by yosoufe on Thu, 2018-03-08 12:34 |
9 |
by yosoufe Tue, 2018-03-20 09:30 |
General discussion | |
|
My VESC TOOL did not have "balance" by Elijah K on Wed, 2020-08-12 07:52 |
by Elijah K Wed, 2020-08-12 07:53 |
General discussion |
Pages
