You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
Motor shutting off due to FAULT_CODE_ABS_OVER_CURRENT by isso777 on Mon, 2022-01-24 13:56 |
5 |
by canoeman Thu, 2022-01-27 18:12 |
General discussion | |
|
Motor Jerks and Cogs and gets Very hot by Robert Thomas on Sun, 2022-09-18 00:40 |
2 |
by Snabelost Thu, 2022-12-08 15:45 |
General discussion | |
|
VESC Connect dongle alternatives by Pimousse on Tue, 2020-06-02 15:32 |
by Pimousse Tue, 2020-06-02 15:32 |
General discussion | ||
|
Controlling BLDC Cordless Router with VESC by CthulhuLabs on Mon, 2020-05-25 16:58 |
4 |
by TheFallen Tue, 2020-06-23 09:44 |
General discussion | |
|
VESC Hardware Design For 4 in 1 Quadcopter ESC Board? by aklimaj on Wed, 2021-01-06 22:55 |
2 |
by TheFallen Mon, 2021-01-11 08:38 |
General discussion | |
|
PWM on output by ml2311 on Tue, 2021-08-24 14:46 |
5 |
by Flyingtux Wed, 2022-03-30 19:31 |
General discussion | |
|
VESC is not working in ADC mode by asnamp on Wed, 2022-04-20 09:21 |
by asnamp Thu, 2022-04-21 20:11 |
General discussion | ||
|
Acceleration control to desired RPM by bjohns on Fri, 2018-07-20 22:08 |
9 |
by arvidb Thu, 2018-08-09 21:15 |
General discussion | |
|
Protect psu from regenerative braking by KarlGreger on Tue, 2020-01-28 03:45 |
4 |
by marc.s.cohn@gma... Tue, 2020-07-07 21:11 |
General discussion | |
|
Flipsky 75/100 Mosfet short? by Michael Campbell on Mon, 2022-04-11 08:29 |
4 |
by Michael Campbell Tue, 2022-04-12 00:03 |
General discussion | |
|
Any way to increase detection time? by VapeGod on Wed, 2023-01-25 05:58 |
by VapeGod Wed, 2023-01-25 05:58 |
General discussion | ||
|
Using Motor hall sensors as the encoder by Russ g on Wed, 2019-05-08 16:01 |
by Russ g Wed, 2019-05-08 16:01 |
General discussion | ||
|
FOC current oscillation at max. speed by ProgramThyself on Mon, 2020-08-10 05:55 |
10 |
by SRFirefox Wed, 2020-08-26 23:10 |
General discussion | |
|
VEC 4.20 50A current limitations by Jean-Michel RAVON on Thu, 2021-03-18 14:16 |
by Jean-Michel RAVON Thu, 2021-03-18 14:16 |
General discussion | ||
|
Roll-to-start VESC by dsuresh on Fri, 2021-03-12 21:05 |
4 |
by robertkovax Fri, 2023-11-10 16:57 |
General discussion | |
|
advice on position control by feskarn on Mon, 2021-02-15 14:47 |
by feskarn Mon, 2021-02-15 14:47 |
General discussion | ||
|
Able to read CAN messages from VESC but cannot write messages to CAN Bus. by willd3543 on Wed, 2023-04-05 23:49 |
3 |
by benjamin Wed, 2023-04-12 07:32 |
General discussion | |
|
Efficiency Control by devin on Sat, 2018-09-29 19:50 |
19 |
by devin Wed, 2019-07-10 19:35 |
General discussion | |
|
ADC Throttle Voltage Issue by Reichen Schaller on Fri, 2022-05-20 01:02 |
5 |
by Gatze Wed, 2022-05-25 17:10 |
General discussion | |
|
E-bike set up by Iangamblin on Fri, 2023-03-24 14:02 |
5 |
by Iangamblin Thu, 2023-06-29 17:35 |
General discussion |
Pages
