You are here
Active forum topics
Primary tabs
| Topic |
Replies |
Last post | Forum | |
|---|---|---|---|---|
|
Vesc with ROS over can bus by meilutisr on Fri, 2021-07-09 18:29 |
1 |
by hiqsol Tue, 2022-10-25 14:23 |
General discussion | |
|
VESC design specification, manual by velolac on Thu, 2020-01-02 15:54 |
1 |
by velolac Sat, 2020-01-11 00:05 |
VESC Original Hardware | |
|
Problems Compiling Firmware by LB94 on Tue, 2022-11-29 00:08 |
1 |
by Daniel... Tue, 2023-09-19 20:17 |
VESC Firmware | |
|
REVERSE FAIL in ADC_CURRENT_REV_BUTTON_BRAKE_ADC by dk-odense on Tue, 2019-12-17 15:45 |
1 |
by benjamin Fri, 2019-12-27 23:09 |
VESC Firmware | |
|
vesc down load by mikeoutlaw24 on Fri, 2018-11-16 02:37 |
1 |
by frank Mon, 2018-12-10 17:32 |
VESC Tool | |
|
Pictures from "Input Setup Wizard for multiple VESCs via CAN-Bus, using a PPM signal radio controller"? by timmertens on Thu, 2022-06-16 17:56 |
1 |
by frank Thu, 2022-06-16 19:47 |
VESC Tool | |
|
Advice on using the VESC 100/250 vs Kelly Controller for 10 kW motorboat by Pilotniq on Fri, 2020-10-23 22:06 |
1 |
by skyline1970 Sun, 2020-10-25 10:29 |
General discussion | |
|
[SOLVED, was a mistake] Set ERPM command: issue with the speed controller with higher speed values that is possible with bat vol by yes_wecangogreen on Wed, 2023-04-12 00:51 |
1 |
by yes_wecangogreen Sat, 2023-04-29 09:24 |
General discussion | |
|
Slow down deacceleration?? by yulaw2k on Tue, 2020-03-17 07:16 |
1 |
by vadicus Wed, 2020-03-18 16:56 |
General discussion | |
|
PID gains by spacemango on Mon, 2020-06-08 21:16 |
1 |
by spacemango Tue, 2020-06-09 16:53 |
General discussion | |
|
Current calculation in BLDC Mode with 3 shunts fails in v6.05 by STMBLUE on Wed, 2023-08-30 19:48 |
1 |
by STMBLUE Thu, 2023-08-31 14:46 |
VESC Development and Beta Testing | |
|
Flipsky 75100foc motor detection sensor issue fails every crysaltemotor I've tried by Wheelzscootersinc on Fri, 2023-02-03 21:36 |
1 |
by tom355 Sun, 2023-02-05 11:11 |
VESC Tool | |
|
DC-Link Capacitor Selection by rushi95 on Sat, 2019-05-18 12:15 |
1 |
by hexakopter Sat, 2019-05-18 12:39 |
General discussion | |
|
PID control with VESC by Hacker king on Mon, 2018-03-05 20:05 |
1 |
by Danny Bokma Tue, 2018-03-06 06:19 |
General discussion | |
|
Multiple VESCs, CANBus, Galvanic Isolation and Puffs of Smoke by KirkusMaximus on Wed, 2023-01-18 00:55 |
1 |
by frank Wed, 2023-01-18 12:29 |
General discussion | |
|
VESC Firmware Change, No Longer Connects by wj311 on Wed, 2021-03-10 22:40 |
1 |
by benjamin Thu, 2021-03-18 10:52 |
VESC Firmware | |
|
Newbie Help please, Longer run time? by Bildoon on Mon, 2020-04-06 02:00 |
1 |
by linsus Thu, 2020-04-16 14:18 |
General discussion | |
|
Detection Problem by ESK8THRASHER on Tue, 2020-11-03 05:38 |
1 |
by TheFallen Tue, 2020-11-03 11:22 |
The VESC-Project | |
|
FOC configuration - Motor stalls during measurement by Lukinio on Wed, 2021-05-26 12:31 |
1 |
by Lukinio Wed, 2021-05-26 12:44 |
VESC Tool | |
|
Difference between ERPM and Duty Cycle by dormanae on Wed, 2022-02-23 17:21 |
1 |
by j.konrad Thu, 2022-02-24 02:08 |
General discussion |
Pages
