You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
Regenerate 30V to charge 40V battery by musinov » Thu, 2021-03-18 19:25 |
2 |
by vadicus Sun, 2021-04-11 19:27 |
|
|
VESC regenerating while RPM increased by olivierskypullc... » Fri, 2019-03-08 16:32 |
2 |
by olivierskypullc... Mon, 2019-03-11 10:45 |
|
|
MOSFET driver delay compensation by e-biker » Sun, 2017-12-10 16:21 |
2 |
by e-biker Tue, 2017-12-12 09:41 |
|
|
FloatWheel not balancing, shooting forward by EvDeck » Fri, 2023-04-14 22:16 |
2 |
by Surefire Sun, 2023-07-09 05:59 |
|
|
Can I change control mode on the fly through the UART port? by spork » Wed, 2019-03-13 02:24 |
2 |
by spork Wed, 2019-03-13 15:41 |
|
|
Inconsistent battery current by Jean Fourcade » Mon, 2020-02-03 06:28 |
2 |
by vadicus Tue, 2020-02-18 20:39 |
|
|
Using STM32F407 for a custom board by kapek » Mon, 2020-04-06 04:16 |
2 |
by vadicus Fri, 2020-04-10 06:31 |
|
|
6 Phase Motor - How to Drive it? by vitormhenrique » Wed, 2020-02-19 05:47 |
2 |
by Badkad Fri, 2020-03-20 19:36 |
|
|
current proportional pwm signal by grkn5434 » Mon, 2020-02-24 11:42 |
2 |
by grkn5434 Mon, 2020-02-24 15:40 |
|
|
VESC efficency in position vs speed mode by vadimz » Mon, 2021-12-20 15:04 |
2 |
by Elwin Mon, 2022-01-03 19:23 |
|
|
Using 13s battery on flipsky FSESCs. Is it safe? by Murilo » Thu, 2022-01-27 02:59 |
2 |
by Murilo Thu, 2022-01-27 20:20 |
|
|
Big Inrunner - Noisy In FOC Mode by skeaux » Mon, 2020-03-02 04:13 |
2 |
by skeaux Tue, 2020-03-03 05:30 |
|
|
Analogue throttle by craig w » Mon, 2022-01-03 07:56 |
2 |
by craig w Mon, 2022-01-03 09:25 |
|
|
Controlling a Tank by JulianT » Thu, 2020-01-23 10:06 |
2 |
by frank Thu, 2023-03-23 18:28 |
|
|
no sensor code by steven@clarkeco... » Mon, 2020-12-07 00:22 |
2 |
by TheFallen Tue, 2020-12-15 12:08 |
|
|
Wiring two VESCs by neuromancer2701 » Mon, 2018-10-01 14:42 |
2 |
by arvidb Wed, 2018-10-03 23:41 |
|
|
Overcurrent fault when braking by maxhertz » Fri, 2022-10-07 09:38 |
2 |
by maxhertz Sun, 2022-10-09 03:34 |
|
|
Small inrunner HFI set-up issue by anthony_ » Thu, 2022-08-11 13:43 |
2 |
by anthony_ Mon, 2022-08-15 13:45 |
|
|
VESC for lower power application by Djmrozinski » Fri, 2020-12-18 06:00 |
2 |
by TechAUmNu Fri, 2020-12-18 11:28 |
|
|
Motor only running in reverse by obex_mike » Mon, 2018-06-25 16:25 |
2 |
by frank Tue, 2018-06-26 12:36 |
|
|
Flipsky 75100 cutting out by moose09876 » Thu, 2022-09-01 22:01 |
2 |
by moose09876 Sat, 2022-09-10 18:23 |
|
|
Motor cogs with no load, especially at high rpm by jurya » Fri, 2020-09-18 17:49 |
2 |
by jurya Fri, 2020-09-18 20:40 |
|
|
Looking for a technical co-founder for a VESC-Based Startup Project by pex » Fri, 2022-10-21 18:35 |
2 |
by pex Sat, 2022-10-22 01:37 |
|
|
VESC 100/250 Voltage spikes? by LondonNight » Mon, 2022-09-05 08:21 |
2 |
by LondonNight Fri, 2022-09-09 18:01 |
|
|
BLDC Variable Speed Trigger for ADC throttle control by KCDEF » Mon, 2020-09-21 01:41 |
2 |
by TheFallen Tue, 2020-09-22 10:53 |
Log in to post new content in the forum.
