You are here

Flipsky 75100 cutting out

3 posts / 0 new
Last post
moose09876
Offline
Last seen: 2 weeks 17 hours ago
VESC Free
Joined: 2022-07-10 13:53
Posts: 14
Flipsky 75100 cutting out

Looking for any ideas on why this thing keeps just dying. Temp is fine, voltage is fine, it's registering duty cycle but not pushing anything to the motor. Issue areas in yellow. I can let it sit all day at full throttle after this and it will do nothing. Have to bring it back to neutral for ~5s, then it'll go again. Almost like it's rebooting, but I don't have any way to log this data other than the graphs.

 

NoDrive.png

NoDrive 2.png

moose09876
Offline
Last seen: 2 weeks 17 hours ago
VESC Free
Joined: 2022-07-10 13:53
Posts: 14

Still unable to figure out why this is happening. No faults, nothing in the debug console. At this point it's unusable. 

NoDrive3.png

moose09876
Offline
Last seen: 2 weeks 17 hours ago
VESC Free
Joined: 2022-07-10 13:53
Posts: 14

Ok. Noob mistake here. I had total maximum amps set way too low and it was throwing an over current fault.