You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
Best practice for controlling VESC with high speed PWM by arsenix » Sun, 2022-01-09 18:29 |
1 |
by skyline1970 Wed, 2022-01-19 09:39 |
|
|
Recording VESC parameters by Alexandru Ciocan » Wed, 2020-03-25 08:44 |
1 |
by Jamie42 Wed, 2020-03-25 12:24 |
|
|
VESC won't turn on - RED LED by TKnque » Mon, 2022-02-14 01:01 |
1 |
by frank Mon, 2022-02-14 07:48 |
|
|
Need Wiring Diagram for 2xLipo Series with 2x MK3 Button Start by adamchicago » Thu, 2020-01-30 19:47 |
1 |
by frank Sat, 2020-02-01 20:27 |
|
|
FOC motor just grinds on speed command, spins up smoothly during parameter calibration by mmiles19 » Wed, 2022-02-16 23:21 |
1 |
by frank Thu, 2022-02-17 07:32 |
|
|
SSI Encoder with VESC by tsharma » Thu, 2022-01-13 17:26 |
1 |
by onur_er Tue, 2023-09-05 15:32 |
|
|
VESC for electric scooter by eyup » Tue, 2022-02-22 13:52 |
1 |
by Filip Kinl Thu, 2022-02-24 13:35 |
|
|
Custom VESC4 hardware - disable Regen? by ben5243 » Mon, 2020-04-13 19:48 |
1 |
by hexakopter Sat, 2020-04-18 16:51 |
|
|
EE Senior Design - Controller Code by Flaz » Wed, 2021-12-08 03:22 |
1 |
by jeremy089786 Wed, 2021-12-08 06:19 |
|
|
Alternator custom VESC hardware: Looking for collaborators by jon@ifold » Wed, 2020-01-15 20:11 |
1 |
by frank Thu, 2020-01-16 16:32 |
|
|
Controling the Vesc via Uart and Matlab? by Michael Hamm » Mon, 2022-01-24 16:47 |
1 |
by Fikret Sonmez Sat, 2022-07-30 06:14 |
|
|
What is limiting my RPMS (VESC 4.2 / Q100H setup) by nckbutler » Tue, 2020-03-03 15:37 |
1 |
by socrace Thu, 2020-03-05 03:50 |
|
|
disappointed with vesc mk6 by KCDEF » Mon, 2020-09-28 20:15 |
1 |
by TechAUmNu Wed, 2020-10-07 15:01 |
|
|
ADC throttle lock. by Billy_Wiz » Mon, 2022-10-31 00:57 |
1 |
by vadicus Mon, 2022-10-31 19:51 |
|
|
stm32/vesc fault limit? by 123seaborder » Sat, 2020-11-21 16:37 |
1 |
by vadicus Sun, 2020-11-22 04:13 |
|
|
VESC on an STM32F4 Discovery board by sonnbc » Tue, 2020-10-06 06:55 |
1 |
by selenakale Thu, 2020-10-22 04:40 |
|
|
How to increase power ? by boursomaster » Sat, 2022-09-24 21:19 |
1 |
by skyline1970 Thu, 2022-11-24 20:19 |
|
|
Tuning prop loads with rapid erpm increase in duty cycle or speed control by mirage98 » Mon, 2022-09-26 01:51 |
1 |
by drummerboy5408 Mon, 2022-10-24 05:49 |
|
|
Hello Members! I need suggestions by Scooter Evolution » Mon, 2020-12-07 16:33 |
1 |
by vadicus Tue, 2020-12-08 00:07 |
|
|
Disabling speed cutoff by RDN2003 » Sat, 2020-10-24 00:25 |
1 |
by frank Tue, 2020-10-27 16:42 |
|
|
Dual motor for a small boat by Snabelost » Wed, 2022-08-24 10:58 |
1 |
by Snabelost Wed, 2022-08-24 13:56 |
|
|
VESC read temperature values with vesc arduino library by roque.canales » Sun, 2020-11-01 12:10 |
1 |
by TheFallen Tue, 2020-11-03 00:27 |
|
|
raptor 2 remote by dave9401 » Mon, 2020-11-02 10:08 |
1 |
by dave9401 Mon, 2020-11-02 10:09 |
|
|
Vesc edu 6 with 2800Kv brushless motor speed control by siklopentan » Sat, 2022-10-15 14:34 |
1 |
by skyline1970 Thu, 2022-11-24 20:12 |
|
|
AS5047 Encoder with VESC 4.20 by rctestflight » Mon, 2020-09-21 19:55 |
1 |
by aparanjpe Sun, 2021-01-03 17:45 |
Log in to post new content in the forum.
