hello good, can someone tell me how to get to the main page of vesc tool where the engines are configured? I have downloaded vesc tool but I can't get to the page where the youtube tutorials explain the settings ... I don't know if I have to download something else ... ?? Thank you
I have a 960KV medium Brussless motor for RC car, it works with standard ESC, but with new VESC motor is not spinning up during detection. It just waits and comes up with success. Any ideas why this could be happening?? I checked my VESC with a different motor and it works and that one spins up, but the other does not. Is there cases where the VESC is just not compatible with the motor? Any help will be appreciated.
Cheers
Hello,
Is it possible to tie a single transmitter (e.g. vx1 or nano from flipsky) with two receivers connected to two different vesc? (ppm mode only)
I was trying to use the same ID for VESC using APP but the transmitter only binds with the receivers one at a time.
Thank you in advance
Vincenzo
Solved
Hi everyone!
I think I have a problem with my hall sensor detection.
1. Problem: The ESC turns randomly off when I use the hall sensors. in sensorless mode, this does not happen
2. Problem: When I try to set the motor to a specific angel it just vibrates really loud and strong.
When I turn my motor with my hand slowly like 1/4 rotation, Realtime Data shows that it turned like 2 times.
Can someone help me whit this problem or do I need to provide more information?
I am using VESC Tool 3.00 on Android to connect over bluetooth. My board is running a dual vesc setup (connected over CAN) with a Flipsky NRF51 bluetooth module connected to the slave VESC.
However I am unable to get logging data from both VESCs. When enabling 'RT data logging' in the developer settings, the resulting CSV file only contains data from the slave VESC. Is it possible to log data for both VESCs?
Hello,
Can someone explain how to connect the VESC4.12 to keyboard/wirless joystick so that I can try to operate the motor with it. It would be great if someone can help me with this
Thank you,
Sanketh
Hi
The documentation images won't load, for example in the link https://vesc-project.com/node/183
The images show as unloaded and cannot be in any way loaded.
Please help!
Thanks
My project requires the can bus be enabled; I have three hub motors and three motor controllers that need to output the same control data from my ADC throttle. I can't seem to get them to connect or come up simultaneously in vesc tool like I did before. Subject title is the same message I get when I go to scan the can bus in the communication tab. This is frustrating because I finally have all the hardware I need to finish this project as of today and now suddenly software issues. How can I get vesc tool to register all three motor controllers?
