You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
esc burning my motor by renaudbarbier on Tue, 2023-02-28 09:38 |
by renaudbarbier Tue, 2023-02-28 17:18 |
General discussion | ||
|
Dutycyle dropping under load by Julzz112 on Sun, 2024-04-14 18:31 |
by Julzz112 Tue, 2024-04-16 08:26 |
General discussion | ||
|
foc with encoder fails to run smoothly by jdn on Thu, 2019-08-22 12:26 |
by jdn Thu, 2019-08-22 15:47 |
General discussion | ||
|
Connection/power problem by PredatorRTX on Fri, 2024-03-29 10:43 |
by PredatorRTX Fri, 2024-03-29 10:43 |
General discussion | ||
|
VescTool version 6.06 Android latest update by Brice77 on Sun, 2025-08-31 17:24 |
2 |
by Brice77 Mon, 2025-09-01 23:55 |
General discussion | |
|
Need help to configure the regenerative brake ... by Loops on Mon, 2019-08-12 19:43 |
2 |
by Loops Wed, 2019-08-14 18:07 |
General discussion | |
|
How does VESC measure the flux? by Jongwon on Thu, 2020-01-30 04:45 |
2 |
by pf26 Mon, 2020-02-10 16:18 |
General discussion | |
|
BEFM (direct drive motor) higher than battery voltage. by BalorNG on Fri, 2021-04-02 18:04 |
1 |
by skyline1970 Sat, 2021-09-18 12:05 |
General discussion | |
|
How to increase the +/-165A rms current limit to 250A+ rms (350-400A peak) by ev_motors on Sat, 2018-04-28 10:18 |
by ev_motors Sat, 2018-04-28 10:18 |
General discussion | ||
|
12v(3s) Input to VESC 75/250 by AliBarrett10 on Wed, 2021-03-24 14:36 |
by AliBarrett10 Wed, 2021-03-24 16:19 |
General discussion | ||
|
Tips on tuning PID for a 170mm RW170 hub motor, 15 pole-pairs, low speed, high torque, 0-3000 ERPM by PaulMakesThings on Fri, 2022-08-05 11:06 |
by PaulMakesThings Fri, 2022-08-05 11:06 |
General discussion | ||
|
Vesc red LED on by dsuresh on Wed, 2021-02-24 18:01 |
by dsuresh Wed, 2021-02-24 18:01 |
General discussion | ||
|
Encoder Ratio for AS5047P by brian.s.stubbs@... on Fri, 2022-06-17 22:09 |
3 |
by XieMaster Fri, 2022-11-11 02:54 |
General discussion | |
|
PPM Signal not recognized by nopf on Mon, 2024-06-17 15:31 |
8 |
by nopf Tue, 2024-07-02 15:01 |
General discussion | |
|
Website updates by benjamin on Fri, 2018-02-23 17:45 |
5 |
by benjamin Wed, 2018-03-14 10:46 |
General discussion | |
|
Separate Deadband for ADC2? by striderkent on Wed, 2019-01-23 16:31 |
by striderkent Wed, 2019-01-23 16:31 |
General discussion | ||
|
PID Position Controller by IanG on Wed, 2020-03-25 03:05 |
5 |
by Luke264 Wed, 2021-02-17 18:53 |
General discussion | |
|
HFI Mode Hoverboard Hub Motor by JulianT on Wed, 2023-04-12 19:16 |
by JulianT Sat, 2023-04-15 11:09 |
General discussion | ||
|
Can not adjust the RPM on my 1350 w motor by Arne Norway on Wed, 2019-01-09 18:47 |
6 |
by sam.vanratt Sun, 2019-01-13 13:36 |
General discussion | |
|
Mine is blinking red three times (4.12) by CADEN_K on Wed, 2020-10-14 05:49 |
1 |
by DMKitsch Sat, 2020-10-24 22:02 |
General discussion |
Pages
