You are here
Active forum topics
Primary tabs
Topic | Replies | Last post | Forum | |
---|---|---|---|---|
DIY VESC 6 "DRV" FAULT by a.dahhak on Thu, 2020-06-11 22:10 |
2 |
by a.dahhak Fri, 2020-06-12 20:06 |
General discussion | |
Motor Overheating in FOC by amanpereira1 on Thu, 2022-05-05 16:14 |
2 |
by Nuppen Wed, 2024-02-14 08:14 |
General discussion | |
Fault:DRV8302 DUAL V4 by Lzx19961014 on Tue, 2018-09-04 11:48 |
3 |
by stone_1706 Sat, 2019-02-02 17:09 |
General discussion | |
Reverse rotation command during forward rotation by nisigundam on Wed, 2018-03-07 09:12 |
5 |
by Josh54 Thu, 2022-09-08 18:08 |
General discussion | |
5V/serial weirdness when using FOC by wihrl on Sat, 2019-06-15 12:57 |
1 |
by frank Fri, 2019-06-28 14:13 |
General discussion | |
Very Large hub motor detection (QSMOTOR 3000W hub) by shaman on Thu, 2020-02-20 01:26 |
5 |
by fart Wed, 2024-04-03 10:43 |
General discussion | |
FOC settings are working in one VESC hardware and not in another VESC hardware with same hardware version ( VESC 6MKVI ) by Pranit Bhamare on Fri, 2023-02-17 07:17 |
by Pranit Bhamare Fri, 2023-02-17 07:17 |
General discussion | ||
FOC Issue by Davideo on Mon, 2018-02-19 03:30 |
6 |
by yosoufe Thu, 2018-03-08 13:19 |
General discussion | |
Reprogram VESC for sensorless motor by Christopherinco... on Thu, 2020-09-03 00:10 |
2 |
by vadicus Thu, 2020-09-03 01:14 |
General discussion | |
when speed of vesc motor too fast and the arduino pin signal is unstable by HumorLogic on Tue, 2021-04-06 14:21 |
3 |
by woliam Sat, 2021-04-10 15:17 |
General discussion | |
Two Motors on same Shaft by Giga93 on Thu, 2017-12-14 10:12 |
5 |
by ThierryGTLTS Sun, 2017-12-17 13:20 |
General discussion | |
Auxiliary Output Mode pin# by garyp on Sat, 2020-08-22 18:17 |
by garyp Sat, 2020-08-22 18:17 |
General discussion | ||
Reverse direction by ISanberg on Sun, 2021-03-28 22:22 |
1 |
by skyline1970 Sat, 2021-09-18 12:01 |
General discussion | |
Set McConf with no values --> bootloader erased? by Kakskiv on Tue, 2017-11-28 12:52 |
3 |
by basti30 Wed, 2018-08-22 22:22 |
General discussion | |
Small inrunner HFI set-up issue by anthony_ on Thu, 2022-08-11 13:43 |
2 |
by anthony_ Mon, 2022-08-15 13:45 |
General discussion | |
Cruise function already implemented? by sam.vanratt on Wed, 2019-01-02 17:05 |
by sam.vanratt Wed, 2019-01-02 17:20 |
General discussion | ||
Sensorless FOC with Duty Cycle will not stop spinning by moose09876 on Mon, 2022-08-01 18:08 |
by moose09876 Mon, 2022-08-01 18:08 |
General discussion | ||
-solved- by KittenDude on Sat, 2020-11-28 06:30 |
by KittenDude Sun, 2020-11-29 19:27 |
General discussion | ||
VESC stopped working, can't connect to USB by Hyperion on Mon, 2018-04-09 16:53 |
6 |
by bloggerjaan Wed, 2020-03-11 12:31 |
General discussion | |
Firmware Update = Quiet Motor? by worldmaverik on Sun, 2020-04-19 21:45 |
by worldmaverik Sun, 2020-04-19 21:45 |
General discussion |