You are here
Active forum topics
Primary tabs
| Topic | Replies |
Last post |
Forum | |
|---|---|---|---|---|
|
ADC throttle lock. by Billy_Wiz on Mon, 2022-10-31 00:57 |
1 |
by vadicus Mon, 2022-10-31 19:51 |
General discussion | |
|
Encoder position resetting to 0° by Michelle90 on Tue, 2022-10-25 18:55 |
1 |
by GijsB Sun, 2022-10-30 20:17 |
General discussion | |
|
Current controller issue - Glitches at low current, low RPM by GijsB on Sun, 2022-10-30 12:59 |
1 |
by GijsB Sun, 2022-10-30 15:37 |
General discussion | |
|
Wow wow by st0r on Sat, 2022-05-07 21:45 |
2 |
by Hansherrman Sun, 2022-10-30 01:40 |
General discussion | |
|
Inquiry about Incremental and Absolute Encoders in VESC for Robotics by sivanhere on Fri, 2022-10-28 21:02 |
by sivanhere Fri, 2022-10-28 21:02 |
General discussion | ||
|
Is this kogging and jitter in low rpms expected? by Snabelost on Sat, 2022-10-22 16:53 |
8 |
by Snabelost Fri, 2022-10-28 16:07 |
General discussion | |
|
Porting VESC to STML4 by Vince_1618 on Fri, 2022-10-28 14:01 |
by Vince_1618 Fri, 2022-10-28 14:01 |
General discussion | ||
|
Issue with VESC I/O on donkey car by baluja on Fri, 2022-10-28 02:56 |
by baluja Fri, 2022-10-28 02:56 |
General discussion | ||
|
How to use an IMU and a PPM remote parallel by Gos1 on Tue, 2022-10-25 15:28 |
by Gos1 Wed, 2022-10-26 10:57 |
General discussion | ||
|
Vesc with ROS over can bus by meilutisr on Fri, 2021-07-09 18:29 |
1 |
by hiqsol Tue, 2022-10-25 14:23 |
General discussion | |
|
Tuning prop loads with rapid erpm increase in duty cycle or speed control by mirage98 on Mon, 2022-09-26 01:51 |
1 |
by drummerboy5408 Mon, 2022-10-24 05:49 |
General discussion | |
|
Electric/ Gas Hybrid by kcswimrac on Wed, 2020-05-06 17:05 |
4 |
by drummerboy5408 Mon, 2022-10-24 05:43 |
General discussion | |
|
Inconsistant braking force when full brake starting to apply by Koxx3 on Sat, 2022-10-22 16:21 |
1 |
by Koxx3 Sun, 2022-10-23 13:22 |
General discussion | |
|
Looking for a technical co-founder for a VESC-Based Startup Project by pex on Fri, 2022-10-21 18:35 |
2 |
by pex Sat, 2022-10-22 01:37 |
General discussion | |
|
Undervoltage Fault by gazlinux on Tue, 2022-02-08 02:26 |
3 |
by 67RS427 Fri, 2022-10-21 20:53 |
General discussion | |
|
Encoder connection by Herbie on Fri, 2019-05-31 15:12 |
11 |
by Dencio1976 Fri, 2022-10-21 13:46 |
General discussion | |
|
Dual motor setup for Turnigy SK8 V2 60A x 2 3~12S Twin Motor Skateboard ESC? by fil02184 on Tue, 2022-10-18 04:07 |
by fil02184 Tue, 2022-10-18 16:00 |
General discussion | ||
|
Slot car ESC? by adrianblakey on Thu, 2022-10-13 11:52 |
1 |
by frank Thu, 2022-10-13 14:49 |
General discussion | |
|
Help needed in controlling multiple VESC boards (multiple motors) with VESC ROS (need to debug errors) by shreyas.srinivasan on Thu, 2022-10-13 08:13 |
by shreyas.srinivasan Thu, 2022-10-13 08:13 |
General discussion | ||
|
UAV motor BLDC detection fails by Torbjorn on Wed, 2022-10-12 13:54 |
1 |
by frank Wed, 2022-10-12 17:04 |
General discussion |
Pages
