You are here
Active forum topics
Primary tabs
Topic | Replies | Last post | Forum | |
---|---|---|---|---|
Vesc 100/250 for unsensored brushless motors by jmurba on Fri, 2022-08-05 12:05 |
3 |
by velolac Fri, 2022-08-12 22:14 |
General discussion | |
Wand speed display incorrect - Solved by hans_maier on Sat, 2019-09-14 15:16 |
4 |
by hans_maier Wed, 2019-09-18 22:31 |
General discussion | |
How the saliency is affecting the High frequency signal injection? by SOURAV UK on Sun, 2020-05-03 11:35 |
by SOURAV UK Sun, 2020-05-03 11:35 |
General discussion | ||
Trampa 100/250 with Cyc x1pro motor high Rpm issue PLZ Help :) by Asi on Thu, 2022-07-28 10:08 |
2 |
by Asi Thu, 2022-07-28 16:12 |
General discussion | |
Can i change the controller (LQFP64) with (LQFP100) with same Firmware? by GalihRiddle on Thu, 2019-09-05 13:44 |
2 |
by GalihRiddle Mon, 2019-09-09 13:22 |
General discussion | |
Battery charging using motor inductance by eptv on Sun, 2020-04-26 07:44 |
by eptv Sun, 2020-04-26 07:44 |
General discussion | ||
I'm trying a VESC in a RC car, but need help. by RandomloserDK on Sun, 2020-11-22 22:55 |
2 |
by RandomloserDK Tue, 2020-11-24 01:14 |
General discussion | |
Flipsky broken off USB ports by mnchvgs79 on Fri, 2021-06-25 20:25 |
by mnchvgs79 Fri, 2021-06-25 20:25 |
General discussion | ||
Getting started with bus control of the VESC by Invert on Mon, 2018-05-21 12:04 |
3 |
by PM Thu, 2018-05-31 18:38 |
General discussion | |
Question about UARTs by melluh on Sun, 2021-06-13 22:50 |
1 |
by vadicus Mon, 2021-06-14 01:15 |
General discussion | |
How to tune BLDC delay mode by Torbjorn on Tue, 2022-11-15 13:21 |
by Torbjorn Tue, 2022-11-15 13:21 |
General discussion | ||
Touchy ADC Connector by ebikerevolution on Thu, 2018-05-10 00:40 |
1 |
by Roger Wolff Thu, 2018-05-10 22:08 |
General discussion | |
Inquiry about Incremental and Absolute Encoders in VESC for Robotics by sivanhere on Fri, 2022-10-28 21:02 |
by sivanhere Fri, 2022-10-28 21:02 |
General discussion | ||
Updated VESC 6 schematic request by ma-j-sterelektron on Mon, 2019-03-25 08:43 |
3 |
by Roby_88 Thu, 2022-08-04 12:43 |
General discussion | |
PAS 3-wire sensor : possible to check a digital input under VESC-toool? by marc426 on Wed, 2021-10-27 00:26 |
6 |
by velolac Thu, 2021-11-25 20:09 |
General discussion | |
75200 vesc by Zander rowley on Tue, 2021-10-12 21:53 |
1 |
by Zander rowley Tue, 2021-10-12 21:56 |
General discussion | |
Motor amps higher than batt amps by minim on Sat, 2019-07-06 22:42 |
1 |
by Stupidspencer Mon, 2019-09-09 18:57 |
General discussion | |
Voltage variation and speed by bdesvaux on Mon, 2022-05-16 12:22 |
1 |
by frank Mon, 2022-05-16 20:52 |
General discussion | |
Motor draws current (up to 120 A), but doesn't turn by Heimfried on Sun, 2020-03-01 22:21 |
by Heimfried Sun, 2020-03-01 22:21 |
General discussion | ||
Controlling Servo via VESC and PPM by bruchpilot123 on Wed, 2020-09-23 13:26 |
1 |
by jarryc Sun, 2021-05-02 01:25 |
General discussion |