You are here
Active forum topics
Primary tabs
| Topic | Replies | Last post |
Forum |
|
|---|---|---|---|---|
|
HALL-FOC---don't understand the mcpwm_foc_hall_detect() function by ConnerL on Wed, 2021-01-06 12:33 |
2 |
by ConnerL Tue, 2021-01-12 02:55 |
General discussion | |
|
Rc controller more than one input ? by zebb.guy@moshon... on Tue, 2022-07-26 14:51 |
2 |
by zebb.guy@moshon... Wed, 2022-07-27 17:22 |
General discussion | |
|
vesc6 help with hub motor by badger1666 on Thu, 2018-12-20 18:36 |
4 |
by badger1666 Fri, 2018-12-21 06:03 |
General discussion | |
|
VESC settings for large scooter motor by trimen on Tue, 2020-07-14 22:15 |
10 |
by Juzy Tue, 2025-04-01 10:58 |
General discussion | |
|
2 vs 3 phase shunts by antonchromjak on Sun, 2018-04-15 13:25 |
13 |
by TechAUmNu Fri, 2019-02-15 18:57 |
General discussion | |
|
current proportional pwm signal by grkn5434 on Mon, 2020-02-24 11:42 |
2 |
by grkn5434 Mon, 2020-02-24 15:40 |
General discussion | |
|
Roll to start by Oded Mazor on Sat, 2023-08-05 11:20 |
by Oded Mazor Sat, 2023-08-05 11:22 |
General discussion | ||
|
current measurements crazy high after replacing DRV8301 with DRV8302, it throws a FAULT_CODE_ABS_OVER_CURRENT by idkanythinggoes on Thu, 2021-03-18 04:34 |
by idkanythinggoes Thu, 2021-03-18 04:34 |
General discussion | ||
|
Motor Driver Voltage Spike Problem by sersam on Sat, 2022-11-12 19:23 |
1 |
by skyline1970 Thu, 2022-11-24 20:00 |
General discussion | |
|
Dual Motor Tracked vehicle by minimivic on Sat, 2023-07-15 18:54 |
1 |
by arthomas Mon, 2023-09-25 00:07 |
General discussion | |
|
Fault code drv by Dominik139 on Wed, 2022-05-04 09:16 |
7 |
by frank Fri, 2022-05-06 08:02 |
General discussion | |
|
error message binding loop detected for property ! wtf by georg65 on Sat, 2024-09-28 08:49 |
by georg65 Tue, 2024-10-01 03:04 |
General discussion | ||
|
Open source hardware? by Jens on Thu, 2017-09-14 18:15 |
3 |
by frank Fri, 2017-09-15 14:01 |
General discussion | |
|
Using A VESC based ESC with another software by Farah on Fri, 2021-03-12 16:20 |
4 |
by Farah Fri, 2021-03-12 21:01 |
General discussion | |
|
Issue with VESC I/O on donkey car by baluja on Fri, 2022-10-28 02:56 |
by baluja Fri, 2022-10-28 02:56 |
General discussion | ||
|
Current control and duty cycle issues. by ESCam on Tue, 2019-04-02 22:55 |
by ESCam Tue, 2019-04-02 22:55 |
General discussion | ||
|
3v3 Regulator fried? How to check if STM was affected too? by Seudo on Fri, 2024-02-16 19:48 |
1 |
by bww129 Fri, 2024-03-15 05:36 |
General discussion | |
|
Send battery voltage as a serial signal to Arduino? by Wall_Nut_ on Sun, 2021-06-06 15:18 |
2 |
by Wall_Nut_ Thu, 2021-06-10 12:09 |
General discussion | |
|
How to control PPM output with CANBUS command by JiaheXu on Thu, 2023-03-30 20:21 |
2 |
by JiaheXu Wed, 2023-04-05 16:52 |
General discussion | |
|
Pole Pairs by donrecardo on Fri, 2020-06-05 10:24 |
4 |
by Bgbalz75 Fri, 2025-05-16 13:01 |
General discussion |
Pages
