You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter | Replies |
Last post |
|
|---|---|---|---|
|
Which App to use and how to wire it by philboslaggins » Sat, 2022-11-05 16:20 |
0 |
by philboslaggins Sat, 2022-11-05 16:20 |
|
|
Unable to turn on Smart Reverse by EBTEAM » Wed, 2022-11-02 08:35 |
1 |
by EBTEAM Wed, 2022-11-02 12:58 |
|
|
ADC throttle lock. by Billy_Wiz » Mon, 2022-10-31 00:57 |
1 |
by vadicus Mon, 2022-10-31 19:51 |
|
|
Encoder position resetting to 0° by Michelle90 » Tue, 2022-10-25 18:55 |
1 |
by GijsB Sun, 2022-10-30 20:17 |
|
|
Current controller issue - Glitches at low current, low RPM by GijsB » Sun, 2022-10-30 12:59 |
1 |
by GijsB Sun, 2022-10-30 15:37 |
|
|
Wow wow by st0r » Sat, 2022-05-07 21:45 |
2 |
by Hansherrman Sun, 2022-10-30 01:40 |
|
|
Inquiry about Incremental and Absolute Encoders in VESC for Robotics by sivanhere » Fri, 2022-10-28 21:02 |
0 |
by sivanhere Fri, 2022-10-28 21:02 |
|
|
Is this kogging and jitter in low rpms expected? by Snabelost » Sat, 2022-10-22 16:53 |
8 |
by Snabelost Fri, 2022-10-28 16:07 |
|
|
Porting VESC to STML4 by Vince_1618 » Fri, 2022-10-28 14:01 |
0 |
by Vince_1618 Fri, 2022-10-28 14:01 |
|
|
Issue with VESC I/O on donkey car by baluja » Fri, 2022-10-28 02:56 |
0 |
by baluja Fri, 2022-10-28 02:56 |
|
|
How to use an IMU and a PPM remote parallel by Gos1 » Tue, 2022-10-25 15:28 |
0 |
by Gos1 Wed, 2022-10-26 10:57 |
|
|
Vesc with ROS over can bus by meilutisr » Fri, 2021-07-09 18:29 |
1 |
by hiqsol Tue, 2022-10-25 14:23 |
|
|
Tuning prop loads with rapid erpm increase in duty cycle or speed control by mirage98 » Mon, 2022-09-26 01:51 |
1 |
by drummerboy5408 Mon, 2022-10-24 05:49 |
|
|
Electric/ Gas Hybrid by kcswimrac » Wed, 2020-05-06 17:05 |
4 |
by drummerboy5408 Mon, 2022-10-24 05:43 |
|
|
Inconsistant braking force when full brake starting to apply by Koxx3 » Sat, 2022-10-22 16:21 |
1 |
by Koxx3 Sun, 2022-10-23 13:22 |
|
|
GPIO Pins on VESC? by phils » Sat, 2022-10-22 17:58 |
1 |
by frank Sat, 2022-10-22 20:37 |
|
|
Looking for a technical co-founder for a VESC-Based Startup Project by pex » Fri, 2022-10-21 18:35 |
2 |
by pex Sat, 2022-10-22 01:37 |
|
|
Undervoltage Fault by gazlinux » Tue, 2022-02-08 02:26 |
3 |
by 67RS427 Fri, 2022-10-21 20:53 |
|
|
Encoder connection by Herbie » Fri, 2019-05-31 15:12 |
11 |
by Dencio1976 Fri, 2022-10-21 13:46 |
|
|
Dual motor setup for Turnigy SK8 V2 60A x 2 3~12S Twin Motor Skateboard ESC? by fil02184 » Tue, 2022-10-18 04:07 |
0 |
by fil02184 Tue, 2022-10-18 16:00 |
|
|
Slot car ESC? by adrianblakey » Thu, 2022-10-13 11:52 |
1 |
by frank Thu, 2022-10-13 14:49 |
|
|
Help needed in controlling multiple VESC boards (multiple motors) with VESC ROS (need to debug errors) by shreyas.srinivasan » Thu, 2022-10-13 08:13 |
0 |
by shreyas.srinivasan Thu, 2022-10-13 08:13 |
|
|
UAV motor BLDC detection fails by Torbjorn » Wed, 2022-10-12 13:54 |
1 |
by frank Wed, 2022-10-12 17:04 |
|
|
Sudden hard acceleration at around 30 km/h. Help by kristofferbenjaminw » Tue, 2022-10-04 17:31 |
4 |
by Chris Barth Tue, 2022-10-11 20:05 |
|
|
Suggestion for new forum area by Snabelost » Thu, 2022-10-06 23:55 |
2 |
by Snabelost Tue, 2022-10-11 18:30 |
Log in to post new content in the forum.
