You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
Motor is "pumping" under load in current control mode. is this normal? by etienne » Sat, 2023-05-13 17:16 |
2 |
by iv.kravchenko Sat, 2023-05-20 08:31 |
|
|
Update FW on multiple VESC pcbs using CAN issue by Offline » Wed, 2021-05-19 15:07 |
2 |
by Offline Wed, 2021-05-26 08:23 |
|
|
4wd rover using hub-motors by mhyer » Thu, 2023-05-18 09:56 |
2 |
by velolac Tue, 2023-05-23 10:03 |
|
|
Flipsky 75100 controller not producing the same amount of power as esc controller at same current by Ashton » Mon, 2021-12-06 21:18 |
2 |
by Liam Li Sun, 2022-03-06 20:31 |
|
|
Issue in encoder mode by limeng06217 » Tue, 2020-02-25 16:48 |
2 |
by limeng06217 Tue, 2020-02-25 16:56 |
|
|
Loud noises at some RPMs by isso777 » Mon, 2022-01-24 16:05 |
2 |
by isso777 Tue, 2022-01-25 10:36 |
|
|
Axial Flow Pump Project by design@imsltd.co.nz » Thu, 2021-12-09 02:05 |
2 |
by design@imsltd.co.nz Fri, 2021-12-10 01:51 |
|
|
Regen Braking / Braking Current under Different Voltages by kimjungyeop » Tue, 2020-02-25 23:47 |
2 |
by Makroman Mon, 2020-07-06 11:58 |
|
|
Push FW .bin File to Controller by vadicus » Wed, 2020-01-15 20:23 |
2 |
by vadicus Thu, 2020-01-16 17:35 |
|
|
motorized kids pedal tractor app configuration by Tom1984 » Thu, 2020-02-27 16:58 |
2 |
by Philipp Spindler Mon, 2020-03-02 15:46 |
|
|
Noob: Enabling VESC 6 MKIII switch and hibernate by adamchicago » Thu, 2020-01-16 16:34 |
2 |
by adamchicago Thu, 2020-01-23 16:52 |
|
|
Remote not receiving telemetry data by jasson » Sun, 2022-02-06 04:21 |
2 |
by jasson Sun, 2022-02-06 05:56 |
|
|
How trottle input by wire? by Heimfried » Mon, 2020-01-27 17:49 |
2 |
by Heimfried Mon, 2020-01-27 21:43 |
|
|
How does VESC measure the flux? by Jongwon » Thu, 2020-01-30 04:45 |
2 |
by pf26 Mon, 2020-02-10 16:18 |
|
|
VESC HD60T CAN DUTY CYCLE CONTROL by v1n23nt » Thu, 2022-02-17 09:39 |
2 |
by v1n23nt Mon, 2022-03-14 16:54 |
|
|
IMU and RC control by marcotrt » Mon, 2020-02-03 22:47 |
2 |
by zmei116 Fri, 2020-12-04 00:43 |
|
|
ESP32 VESC controller by Ortsac » Fri, 2022-01-21 18:50 |
2 |
by Gatze Wed, 2022-03-23 10:50 |
|
|
Are all VESC based ESCs within the same generation standardized in their sensors and data payloads? by pearlgreymusic » Sat, 2022-08-27 11:43 |
2 |
by pearlgreymusic Tue, 2022-09-06 14:24 |
|
|
I have soldered MPU 9150 onto my ESC - How can I confirm that it is working? by delond » Sat, 2018-07-14 15:05 |
2 |
by lock Tue, 2018-07-17 02:26 |
|
|
Flipsky 4.20 FOC settings Not Saving by erwinramos1010 » Mon, 2022-09-05 15:22 |
2 |
by wjpremerlani Sat, 2022-09-24 01:05 |
|
|
DRV8301 always fault by NIKTEN96 » Fri, 2020-11-13 21:23 |
2 |
by Craig_Gault Tue, 2023-02-07 17:56 |
|
|
Problem- Regen tripping out BMS on battery pack by jasontwd » Sun, 2018-07-29 10:10 |
2 |
by jzy1115 Tue, 2018-07-31 06:11 |
|
|
Current limit problem by albheim » Fri, 2022-09-09 10:34 |
2 |
by albheim Fri, 2022-09-09 13:24 |
|
|
Vesc board on ebike by tailele » Sat, 2020-11-14 15:08 |
2 |
by tonyXHB Tue, 2020-12-22 12:21 |
|
|
Motor Jerks and Cogs and gets Very hot by Robert Thomas » Sun, 2022-09-18 00:40 |
2 |
by Snabelost Thu, 2022-12-08 15:45 |
Log in to post new content in the forum.
