You are here
Active forum topics
Primary tabs
| Topic | Replies |
Last post |
Forum | |
|---|---|---|---|---|
|
Noised signal from motor NTC sensor | HW4.12 FW3.27 by ma-j-sterelektron on Wed, 2017-09-06 18:41 |
10 |
by vescsci Wed, 2020-07-15 22:47 |
General discussion | |
|
FOC vs. BLDC by CTSchorsch on Wed, 2020-07-15 13:15 |
by CTSchorsch Wed, 2020-07-15 13:15 |
General discussion | ||
|
What's wrong with my motors? by Mads7400 on Fri, 2020-05-08 15:05 |
1 |
by tylr_r Wed, 2020-07-15 01:22 |
General discussion | |
|
New to electric skateboards - Can't seem to get FSESC set up properly by iguanahotsauce on Sun, 2020-07-12 06:11 |
1 |
by transcendStaticMode Tue, 2020-07-14 07:56 |
General discussion | |
|
Hoverboard Motor with VESC by mados73 on Wed, 2018-03-21 22:14 |
12 |
by Kirkness Mon, 2020-07-13 01:00 |
General discussion | |
|
Issue connecting to ESC 4.12 by Kirkness on Wed, 2020-07-08 01:40 |
2 |
by TheFallen Thu, 2020-07-09 18:01 |
General discussion | |
|
Regenerative braking in scooter Zero x11 72V dual motor 2 x 1600 w peak power 6000W by Makroman on Wed, 2020-07-08 20:00 |
by Makroman Wed, 2020-07-08 20:00 |
General discussion | ||
|
Protect psu from regenerative braking by KarlGreger on Tue, 2020-01-28 03:45 |
4 |
by marc.s.cohn@gma... Tue, 2020-07-07 21:11 |
General discussion | |
|
ADC input protection proposal by arestechfinland on Mon, 2020-07-06 19:41 |
by arestechfinland Mon, 2020-07-06 19:41 |
General discussion | ||
|
Regen Braking / Braking Current under Different Voltages by kimjungyeop on Tue, 2020-02-25 23:47 |
2 |
by Makroman Mon, 2020-07-06 11:58 |
General discussion | |
|
Using VESC to drive sensorless linear motor to simulate on/off solenoid by cmcraeslo on Wed, 2020-07-01 09:15 |
1 |
by pf26 Mon, 2020-07-06 11:10 |
General discussion | |
|
Regen braking not working? by forcefed on Thu, 2018-04-05 01:57 |
3 |
by Makroman Sun, 2020-07-05 16:12 |
General discussion | |
|
VESC 6 Mark III and Traxxas Summit Radio Receiver PWM / PPM Signals by j98221@gmail.com on Fri, 2020-07-03 07:27 |
by j98221@gmail.com Fri, 2020-07-03 07:27 |
General discussion | ||
|
simulate turboprop engine ... using VESC, how to.... by Eckehard on Wed, 2020-06-10 22:32 |
17 |
by Eckehard Thu, 2020-07-02 22:34 |
General discussion | |
|
Runaway Motor with No BLE by Marctwo on Thu, 2020-07-02 20:47 |
by Marctwo Thu, 2020-07-02 20:47 |
General discussion | ||
|
connecting vesc tool with Prototipo by Govert on Thu, 2020-07-02 19:43 |
by Govert Thu, 2020-07-02 19:43 |
General discussion | ||
|
Requesting fault codes over UART by spork on Wed, 2020-06-24 09:02 |
1 |
by Pimousse Wed, 2020-07-01 12:50 |
General discussion | |
|
Optimizing VESC6 setup for my Giant Lego Go-Kart project by mantisrobot on Thu, 2020-06-18 13:29 |
3 |
by TechAUmNu Mon, 2020-06-29 10:19 |
General discussion | |
|
Using the built-in gyro for RC cars by maxpla on Fri, 2020-06-26 10:49 |
1 |
by TechAUmNu Fri, 2020-06-26 16:09 |
General discussion | |
|
How to confirm valid FOC operation? by _johnny_ on Wed, 2020-06-24 11:29 |
by _johnny_ Wed, 2020-06-24 11:29 |
General discussion |
Pages
