You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
E vehicle setup by jordanlow » Wed, 2019-03-20 10:33 |
4 |
by jordanlow Wed, 2019-03-20 16:18 |
|
|
BIG Flash/Spark!!!!! New 100v/250a :-( by Fpvlee » Thu, 2021-05-13 03:17 |
4 |
by Fpvlee Tue, 2021-05-25 00:12 |
|
|
Max Rpm sensorless BLDC by edwink89 » Mon, 2021-03-29 00:15 |
4 |
by CTSchorsch Tue, 2021-03-30 07:12 |
|
|
Using A VESC based ESC with another software by Farah » Fri, 2021-03-12 16:20 |
4 |
by Farah Fri, 2021-03-12 21:01 |
|
|
Can't receive status message via CAN bus by IanG » Mon, 2020-04-13 03:50 |
4 |
by olivierabristol Sun, 2022-02-27 08:31 |
|
|
Why use sensorless if the motor has sensors? by j.konrad » Thu, 2022-02-17 14:25 |
4 |
by j.konrad Mon, 2022-02-21 15:06 |
|
|
MOSFET failure and replacement, stormcore 60d by Airatic » Wed, 2022-01-19 11:36 |
4 |
by j.konrad Sat, 2022-01-22 01:17 |
|
|
FSESC6.6+ Over Voltage Fault 80mm Motors by Yomiel » Fri, 2020-03-20 03:45 |
4 |
by TheFallen Mon, 2021-03-01 16:47 |
|
|
Protect psu from regenerative braking by KarlGreger » Tue, 2020-01-28 03:45 |
4 |
by marc.s.cohn@gma... Tue, 2020-07-07 21:11 |
|
|
ADC throttle with braking by adobe75 » Thu, 2020-10-29 02:26 |
4 |
by gooki Mon, 2021-12-27 07:07 |
|
|
Dead VESC. Power up when motor is spinning. by Bor Zabric » Mon, 2018-10-08 10:16 |
4 |
by striderkent Fri, 2019-01-11 18:46 |
|
|
Back EMF or motor voltage back to the supply by bdesvaux » Tue, 2022-09-27 09:22 |
4 |
by bdesvaux Wed, 2022-09-28 15:52 |
|
|
VESC amplifier ? by Markula » Fri, 2020-11-13 14:52 |
4 |
by s0313045 Mon, 2020-11-16 23:50 |
|
|
foc observer/phase loosing track at phase current limit by Teslafly » Tue, 2018-07-24 18:46 |
4 |
by cir7 Thu, 2022-07-14 17:07 |
|
|
Has anyone tried Dc mode by TechAUmNu » Sun, 2018-05-13 14:28 |
4 |
by TechAUmNu Mon, 2018-05-14 15:16 |
|
|
Sudden hard acceleration at around 30 km/h. Help by kristofferbenjaminw » Tue, 2022-10-04 17:31 |
4 |
by Chris Barth Tue, 2022-10-11 20:05 |
|
|
VESC - FAULT_CODE_DRV : motor no more spinning by piepolitb » Sat, 2018-05-19 12:27 |
4 |
by seif Wed, 2020-03-11 20:12 |
|
|
Custom controlling software by neuromancer2701 » Tue, 2018-09-04 02:09 |
4 |
by LogixCraft Mon, 2022-01-03 13:33 |
|
|
FOC VESC for QS Motor 205 50H 3000w by karlisakis » Mon, 2021-06-07 21:29 |
4 |
by vadicus Mon, 2021-10-25 19:39 |
|
|
Wand speed display incorrect - Solved by hans_maier » Sat, 2019-09-14 15:16 |
4 |
by hans_maier Wed, 2019-09-18 22:31 |
|
|
Driver explosion by fer-bo » Mon, 2021-07-05 11:48 |
4 |
by fer-bo Wed, 2021-07-07 14:50 |
|
|
Trampa VESC6 USB connectivity problem caused by usb hub? by hagoston » Tue, 2021-06-01 10:27 |
4 |
by hagoston Wed, 2021-06-02 09:27 |
|
|
Flipsky 75/100 Mosfet short? by Michael Campbell » Mon, 2022-04-11 08:29 |
4 |
by Michael Campbell Tue, 2022-04-12 00:03 |
|
|
Positional Control, Hall Sensor by wdaehn » Fri, 2017-12-08 15:02 |
4 |
by wdaehn Mon, 2017-12-25 09:46 |
|
|
FOC : Stop Motor without Active Brake by Flyingtux » Mon, 2022-03-14 12:35 |
4 |
by Flyingtux Tue, 2022-03-15 23:09 |
Log in to post new content in the forum.
