You are here
General discussion
Log in to post new content in the forum.
Topic / Topic starter |
Replies | Last post | |
|---|---|---|---|
|
VESC 6 EDU: Motor Wizard - Detection failed by Navigator_PJE » Mon, 2022-08-29 16:12 |
0 |
by Navigator_PJE Mon, 2022-08-29 16:12 |
|
|
VESC 6 DC motor Current limit? by ShortCircuit » Thu, 2019-02-07 21:56 |
14 |
by ShortCircuit Thu, 2019-03-14 19:34 |
|
|
VESC 6 ADC input voltage by thomasjfox » Sat, 2017-10-07 01:41 |
1 |
by ThierryGTLTS Sat, 2017-10-07 12:54 |
|
|
VESC 6 75V, sensor voltage switch? by Alistair Goodman » Wed, 2022-09-28 15:53 |
2 |
by frank Wed, 2022-09-28 16:44 |
|
|
VESC 5.01 + ESP8266 + UART no data received? by i-make-robots » Wed, 2020-07-15 20:09 |
3 |
by Nickklas Tue, 2021-04-27 12:08 |
|
|
VESC 4.20 Schematic by evbkez » Fri, 2019-09-20 07:59 |
3 |
by TheFallen Fri, 2019-09-27 17:45 |
|
|
VESC 4.12 with big-BLDC problem by sam.vanratt » Mon, 2018-12-10 15:59 |
6 |
by sam.vanratt Thu, 2019-01-03 17:44 |
|
|
VESC 4.12 in a CityEL by twikis » Fri, 2018-01-12 15:54 |
6 |
by Roger Wolff Sat, 2018-01-20 16:14 |
|
|
VESC 4.12 FW5.02 CAN status messages is spamming bus, external controller, SOLVED: NEEDED INIT! by Offline » Mon, 2021-05-03 14:57 |
1 |
by Offline Tue, 2021-05-04 10:03 |
|
|
VESC 4.12 Current limit question by jamesk18@vt.edu » Tue, 2024-03-26 18:30 |
0 |
by jamesk18@vt.edu Tue, 2024-03-26 18:30 |
|
|
vesc 100250 Off-the-shelf motor by cuaxr » Mon, 2021-10-25 11:59 |
0 |
by cuaxr Mon, 2021-10-25 11:59 |
|
|
VESC 100/250: analog regen brake AND e-brake cut switch? by fatty » Thu, 2021-05-13 01:16 |
2 |
by frank Mon, 2022-05-02 09:11 |
|
|
VESC 100/250 Voltage spikes? by LondonNight » Mon, 2022-09-05 08:21 |
2 |
by LondonNight Fri, 2022-09-09 18:01 |
|
|
VESC 100/250 missing hall sensor plug by steve1428 » Sat, 2023-04-08 10:00 |
1 |
by iv.kravchenko Fri, 2023-05-19 22:26 |
|
|
VESC 100/250 IO Ports Protection by luke.flecknell » Wed, 2022-03-30 06:49 |
2 |
by luke.flecknell Wed, 2022-03-30 12:41 |
|
|
Vesc 100/250 for unsensored brushless motors by jmurba » Fri, 2022-08-05 12:05 |
3 |
by velolac Fri, 2022-08-12 22:14 |
|
|
VESC 100/250 For sale by jakemansbach » Sun, 2023-02-05 04:22 |
2 |
by EliProtiva Tue, 2023-02-28 00:12 |
|
|
Vesc 100/250 (Trampa board) wiring for ebike by Oded Mazor » Fri, 2022-03-18 23:34 |
8 |
by Markula Fri, 2022-04-01 09:21 |
|
|
VESC 100/250 by XBO » Tue, 2021-09-07 19:25 |
4 |
by frank Mon, 2021-09-20 14:01 |
|
|
VESC 100/250 by PBR-Automatyka » Tue, 2021-11-02 12:17 |
1 |
by PBR-Automatyka Tue, 2021-11-02 12:18 |
|
|
Vesc - UAVCAN - Pixhawk by dbau » Tue, 2022-02-01 07:43 |
1 |
by dbau Tue, 2022-02-01 07:57 |
|
|
VESC - Motor will not start until a small kick is applied from a full stop despite using hall sensors by 010203040506070809 » Wed, 2019-10-23 23:12 |
0 |
by 010203040506070809 Wed, 2019-10-23 23:12 |
|
|
VESC - FAULT_CODE_DRV : motor no more spinning by piepolitb » Sat, 2018-05-19 12:27 |
4 |
by seif Wed, 2020-03-11 20:12 |
|
|
VESC - custom board by st0r » Wed, 2023-03-08 12:21 |
5 |
by st0r Sat, 2023-04-01 01:51 |
|
|
VESC "underpowered" vs Kunteng Controller experience by andyw2005 » Thu, 2021-10-21 23:54 |
1 |
by Elwin Fri, 2021-10-22 11:39 |
Log in to post new content in the forum.
