You are here
General discussion
Log in to post new content in the forum.
Topic / Topic starter | Replies | Last post | |
---|---|---|---|
What is current KP and current KI by Jovan » Fri, 2020-06-19 06:17 |
1 |
by spacemango Fri, 2020-06-19 16:27 |
|
External IMU and Bluetooth by Montaire » Mon, 2020-04-27 11:57 |
2 |
by Montaire Sat, 2020-06-20 13:13 |
|
Controlling BLDC Cordless Router with VESC by CthulhuLabs » Mon, 2020-05-25 16:58 |
4 |
by TheFallen Tue, 2020-06-23 09:44 |
|
Hall sensor table by spacemango » Tue, 2020-06-16 15:47 |
5 |
by pf26 Tue, 2020-06-23 15:10 |
|
Is it possible flash this esc with ? (leopard hoby wp 200A) by Thiery Vardon » Sun, 2020-06-21 13:05 |
1 |
by hexakopter Tue, 2020-06-23 19:42 |
|
How to confirm valid FOC operation? by _johnny_ » Wed, 2020-06-24 11:29 |
0 |
by _johnny_ Wed, 2020-06-24 11:29 |
|
Using the built-in gyro for RC cars by maxpla » Fri, 2020-06-26 10:49 |
1 |
by TechAUmNu Fri, 2020-06-26 16:09 |
|
Optimizing VESC6 setup for my Giant Lego Go-Kart project by mantisrobot » Thu, 2020-06-18 13:29 |
3 |
by TechAUmNu Mon, 2020-06-29 10:19 |
|
Requesting fault codes over UART by spork » Wed, 2020-06-24 09:02 |
1 |
by Pimousse Wed, 2020-07-01 12:50 |
|
connecting vesc tool with Prototipo by Govert » Thu, 2020-07-02 19:43 |
0 |
by Govert Thu, 2020-07-02 19:43 |
|
Runaway Motor with No BLE by Marctwo » Thu, 2020-07-02 20:47 |
0 |
by Marctwo Thu, 2020-07-02 20:47 |
|
simulate turboprop engine ... using VESC, how to.... by Eckehard » Wed, 2020-06-10 22:32 |
17 |
by Eckehard Thu, 2020-07-02 22:34 |
|
VESC 6 Mark III and Traxxas Summit Radio Receiver PWM / PPM Signals by j98221@gmail.com » Fri, 2020-07-03 07:27 |
0 |
by j98221@gmail.com Fri, 2020-07-03 07:27 |
|
Regen braking not working? by forcefed » Thu, 2018-04-05 01:57 |
3 |
by Makroman Sun, 2020-07-05 16:12 |
|
Using VESC to drive sensorless linear motor to simulate on/off solenoid by cmcraeslo » Wed, 2020-07-01 09:15 |
1 |
by pf26 Mon, 2020-07-06 11:10 |
|
Regen Braking / Braking Current under Different Voltages by kimjungyeop » Tue, 2020-02-25 23:47 |
2 |
by Makroman Mon, 2020-07-06 11:58 |
|
ADC input protection proposal by arestechfinland » Mon, 2020-07-06 19:41 |
0 |
by arestechfinland Mon, 2020-07-06 19:41 |
|
Protect psu from regenerative braking by KarlGreger » Tue, 2020-01-28 03:45 |
4 |
by marc.s.cohn@gma... Tue, 2020-07-07 21:11 |
|
Regenerative braking in scooter Zero x11 72V dual motor 2 x 1600 w peak power 6000W by Makroman » Wed, 2020-07-08 20:00 |
0 |
by Makroman Wed, 2020-07-08 20:00 |
|
Issue connecting to ESC 4.12 by Kirkness » Wed, 2020-07-08 01:40 |
2 |
by TheFallen Thu, 2020-07-09 18:01 |
|
Hoverboard Motor with VESC by mados73 » Wed, 2018-03-21 22:14 |
12 |
by Kirkness Mon, 2020-07-13 01:00 |
|
New to electric skateboards - Can't seem to get FSESC set up properly by iguanahotsauce » Sun, 2020-07-12 06:11 |
1 |
by transcendStaticMode Tue, 2020-07-14 07:56 |
|
What's wrong with my motors? by Mads7400 » Fri, 2020-05-08 15:05 |
1 |
by tylr_r Wed, 2020-07-15 01:22 |
|
FOC vs. BLDC by CTSchorsch » Wed, 2020-07-15 13:15 |
0 |
by CTSchorsch Wed, 2020-07-15 13:15 |
|
Noised signal from motor NTC sensor | HW4.12 FW3.27 by ma-j-sterelektron » Wed, 2017-09-06 18:41 |
10 |
by vescsci Wed, 2020-07-15 22:47 |
Log in to post new content in the forum.