You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter | Replies |
Last post |
|
|---|---|---|---|
|
controlling 2 motors for two directions each by ori harush » Mon, 2022-06-06 07:17 |
4 |
by Indy8976 Tue, 2022-06-21 13:36 |
|
|
Can control Vesc 100/250 by David_1 » Sat, 2022-06-18 01:31 |
1 |
by David_1 Sun, 2022-06-19 19:44 |
|
|
Suddenly broken by moto_guy » Fri, 2019-03-08 13:50 |
10 |
by David_1 Fri, 2022-06-17 21:07 |
|
|
Wiring a touchscreen to a vesc by posthy » Tue, 2022-06-14 10:22 |
3 |
by frank Thu, 2022-06-16 08:35 |
|
|
Wrong CAN termination resistor? by DarioP » Mon, 2022-06-13 21:27 |
3 |
by frank Thu, 2022-06-16 08:33 |
|
|
Why is the speed lower in FOC mode than BLDC mode ? by stone_1706 » Thu, 2019-01-17 08:23 |
8 |
by speed3r Wed, 2022-06-15 09:34 |
|
|
PPM duty cycle option not being stored in EEPROM by wjpremerlani » Wed, 2022-06-08 12:49 |
4 |
by frank Thu, 2022-06-09 09:07 |
|
|
Cant get Rotor position to work by nancio » Mon, 2022-06-06 20:47 |
3 |
by frank Thu, 2022-06-09 09:05 |
|
|
Getting a specified rpm via ROS node by Owl Robot » Fri, 2022-05-20 17:38 |
1 |
by x78163 Wed, 2022-06-08 19:21 |
|
|
Because..why not: Full Self Riding Skateboard (autonomous skateboard) by x78163 » Wed, 2022-06-08 17:33 |
0 |
by x78163 Wed, 2022-06-08 17:33 |
|
|
Working on Open Source Remote Control for Differential Drive Robot using BLE by ilektron » Tue, 2021-11-30 03:02 |
1 |
by x78163 Wed, 2022-06-08 17:07 |
|
|
VESC as a grid Tie inverter by pf26 » Thu, 2022-04-07 15:20 |
6 |
by pf26 Tue, 2022-06-07 18:43 |
|
|
VESC as generator - settings confirmation by justinlsquire » Mon, 2022-06-06 02:44 |
0 |
by justinlsquire Mon, 2022-06-06 02:44 |
|
|
Flipsky 75200 with 80100 80kv by ors150 » Tue, 2021-09-14 20:03 |
2 |
by Oded Mazor Sat, 2022-06-04 15:17 |
|
|
Abs over current by Phill Dixon » Fri, 2022-06-03 17:26 |
0 |
by Phill Dixon Fri, 2022-06-03 17:26 |
|
|
Two Vesc6 MKV twin arrays ESC's - BMS CAN BUS connectivity by Spaceman » Fri, 2022-05-27 16:22 |
3 |
by Spaceman Fri, 2022-06-03 15:36 |
|
|
I need clarification on connecting a Magura 0-5k Ohm Pot Twist Throttle to Tronic 250 VESC. by notahorse » Fri, 2022-06-03 08:13 |
0 |
by notahorse Fri, 2022-06-03 08:13 |
|
|
Segway tuning for a project using 2 VESC based ESCs by Clayton Haight » Wed, 2022-06-01 05:03 |
1 |
by frank Wed, 2022-06-01 11:04 |
|
|
Sourcing vesc hardware without paying ”brexit tax”? by st0r » Thu, 2022-05-26 05:24 |
3 |
by frank Mon, 2022-05-30 07:57 |
|
|
Range not showing accurately by th3jonathan » Tue, 2022-05-24 17:43 |
5 |
by frank Mon, 2022-05-30 07:53 |
|
|
Need some help on motor config and app config for Flypsky 65161 motor with FSESC75200 75V by freedomBoogie » Thu, 2021-03-04 09:30 |
2 |
by JoeSwe Sun, 2022-05-29 17:26 |
|
|
ADC Throttle Voltage Issue by Reichen Schaller » Fri, 2022-05-20 01:02 |
5 |
by Gatze Wed, 2022-05-25 17:10 |
|
|
Máximo Voltaje Android by Oscarmanassan » Mon, 2022-05-23 18:49 |
3 |
by frank Wed, 2022-05-25 07:59 |
|
|
Stuck at 150 battery amps... by AlexLTDLX » Sun, 2022-02-13 03:00 |
37 |
by AlexLTDLX Sat, 2022-05-21 20:03 |
|
|
Slow acceleration / no initial torque? by tobe81cwb » Fri, 2022-05-20 00:04 |
1 |
by Gatze Sat, 2022-05-21 17:16 |
Log in to post new content in the forum.
