You are here
General discussion
Log in to post new content in the forum.
| Topic / Topic starter |
Replies |
Last post | |
|---|---|---|---|
|
Starting rotation by changing duty cicle- current increases shortly (ms) and dcreases immediately to 0A by simon_snow » Wed, 2021-10-06 22:15 |
4 |
by simon_snow Fri, 2021-10-08 12:49 |
|
|
trying to get torque with speed (flipsky 75100) by Trecit0n » Fri, 2025-08-01 21:19 |
4 |
by Trecit0n Tue, 2025-08-12 00:05 |
|
|
Motor temperature increase by e-biker » Sun, 2018-04-08 20:17 |
4 |
by e-biker Mon, 2018-04-09 14:44 |
|
|
Block waves with FOC by spacemango » Fri, 2020-06-26 09:48 |
4 |
by Lisa1812 Fri, 2020-09-18 11:56 |
|
|
Difference between Brake Current, Full Brake etc by wdaehn » Wed, 2018-02-21 15:32 |
4 |
by rodread Sat, 2018-03-03 10:45 |
|
|
please delete！ by return97 » Sat, 2022-07-23 17:31 |
4 |
by return97 Wed, 2023-03-29 17:28 |
|
|
Can't connect to VESC's? Linux, need help? by ex-Gooserider » Wed, 2020-08-12 04:38 |
4 |
by ex-Gooserider Wed, 2020-08-19 01:39 |
|
|
Firmware update thru UART? by cromoly » Tue, 2018-04-17 01:19 |
4 |
by cromoly Fri, 2018-04-20 19:22 |
|
|
VESC behaviour as constant torque winch by devmonkey » Thu, 2020-07-09 23:43 |
4 |
by district9prawn Mon, 2020-08-10 13:21 |
|
|
Removing low speed openloop FOC parking brake mode from FW by rodread » Thu, 2018-03-08 15:01 |
4 |
by arvidb Wed, 2018-06-06 19:02 |
|
|
controlling 2 motors for two directions each by ori harush » Mon, 2022-06-06 07:17 |
4 |
by Indy8976 Tue, 2022-06-21 13:36 |
|
|
PPM duty cycle option not being stored in EEPROM by wjpremerlani » Wed, 2022-06-08 12:49 |
4 |
by frank Thu, 2022-06-09 09:07 |
|
|
Can motor parameters be detected with shaft load? by powerlabor001 » Thu, 2018-03-15 13:24 |
4 |
by powerlabor001 Sat, 2018-03-24 03:07 |
|
|
half speed on FOC vs BLDC by ever.summer » Tue, 2019-05-28 00:04 |
4 |
by ever.summer Tue, 2019-05-28 04:34 |
|
|
Using A VESC based ESC with another software by Farah » Fri, 2021-03-12 16:20 |
4 |
by Farah Fri, 2021-03-12 21:01 |
|
|
BLDC vs FOC mode， motor‘s spin direction is invert by moto_guy » Wed, 2019-02-20 11:48 |
4 |
by moto_guy Sun, 2019-02-24 09:11 |
|
|
Updated VESC 6 schematic request by ma-j-sterelektron » Mon, 2019-03-25 08:43 |
4 |
by jejaj25773 Fri, 2024-07-26 02:29 |
|
|
BIG Flash/Spark!!!!! New 100v/250a :-( by Fpvlee » Thu, 2021-05-13 03:17 |
4 |
by Fpvlee Tue, 2021-05-25 00:12 |
|
|
Pitting VESC Six EDU against a Castle Creations ESC - the Castle is winning? by jschall » Fri, 2023-07-14 18:58 |
4 |
by drummerboy5408 Thu, 2023-11-02 23:24 |
|
|
Max Rpm sensorless BLDC by edwink89 » Mon, 2021-03-29 00:15 |
4 |
by CTSchorsch Tue, 2021-03-30 07:12 |
|
|
static torque control by wjpremerlani » Sun, 2023-05-14 13:52 |
4 |
by wjpremerlani Sat, 2023-05-20 12:23 |
|
|
MOSFET failure and replacement, stormcore 60d by Airatic » Wed, 2022-01-19 11:36 |
4 |
by j.konrad Sat, 2022-01-22 01:17 |
|
|
Can't receive status message via CAN bus by IanG » Mon, 2020-04-13 03:50 |
4 |
by olivierabristol Sun, 2022-02-27 08:31 |
|
|
FSESC6.6+ Over Voltage Fault 80mm Motors by Yomiel » Fri, 2020-03-20 03:45 |
4 |
by TheFallen Mon, 2021-03-01 16:47 |
|
|
Protect psu from regenerative braking by KarlGreger » Tue, 2020-01-28 03:45 |
4 |
by marc.s.cohn@gma... Tue, 2020-07-07 21:11 |
Log in to post new content in the forum.
