You are here

Disable Regen braking below set erpm

2 posts / 0 new
Last post
HighV3locity
Offline
Last seen: 7 months 1 week ago
Joined: 2024-03-22 21:16
Posts: 3
Disable Regen braking below set erpm

Is there a way to disable regen breaking when below a certain RPM or erpm while using ADC brake center throttle control. Don't want the brake active when stopped or under 5mph. Makes backing up or moving the bike around a hassle. 

flez1966
Offline
Last seen: 4 months 2 weeks ago
Joined: 2024-03-16 14:49
Posts: 7

I do hope someone answers you on this as I have the same issue with mine, and not only does it  make moving it a pain but I am using a keyswitch to the SW line and if its  in regen it ignores the key switching off until the throttle is at a neutral position, so i have to remove the key and 'blip' the throttle to fully power down, if i forget its not a huge power drain but the ''holding current' through the hub causes interference into the bikes alarm, so i walk away and 1-5minutes later the alarm goes off annoying everyone...

flez1966