Looking for any ideas on why this thing keeps just dying. Temp is fine, voltage is fine, it's registering duty cycle but not pushing anything to the motor. Issue areas in yellow. I can let it sit all day at full throttle after this and it will do nothing. Have to bring it back to neutral for ~5s, then it'll go again. Almost like it's rebooting, but I don't have any way to log this data other than the graphs.
Still unable to figure out why this is happening. No faults, nothing in the debug console. At this point it's unusable.
Ok. Noob mistake here. I had total maximum amps set way too low and it was throwing an over current fault.