You are here

Home » Forums » VESC Firmware

VESC Firmware update not working

2 posts / 0 new
Log in or register to post comments
Last post
Wed, 2019-07-31 18:42
#1
timhermanson94
Offline
Last seen: 4 years 3 months ago
Joined: 2019-07-18 23:42
Posts: 2
VESC Firmware update not working

Hi - 

 

I recently bought a new pre-built Trampa board with 2 VESC 6s. One is on firmware 3.48 and the other on 3.57 and I am trying to set them up using the new VESC tool 1.16. It tells me that I need to update the firmware everytime they connect, but every time I update it secussfully goes through but then when it reboots it's on the same exact firmware and not updating. Is there anything else I can try? 

 

Thanks,

Tim 

Top
Fri, 2019-08-02 15:22
skyline1970
Offline
Last seen: 1 year 2 weeks ago
VESC Free
Joined: 2017-09-07 22:28
Posts: 232

Firstly, at fw bootloder tab, update bootloader, wait 20 secondns after completion of the process. Then, update right fw on exact hw version . After completed, wait about 30 secondns, and make it off, wait, on again.

If not successfull, use swd programming . it is described blow

http://vedder.se/

Connecting a programmer/debugger to my custom STM32 PCBs

 

Top