Hi -
I recently bought a new pre-built Trampa board with 2 VESC 6s. One is on firmware 3.48 and the other on 3.57 and I am trying to set them up using the new VESC tool 1.16. It tells me that I need to update the firmware everytime they connect, but every time I update it secussfully goes through but then when it reboots it's on the same exact firmware and not updating. Is there anything else I can try?
Thanks,
Tim
Firstly, at fw bootloder tab, update bootloader, wait 20 secondns after completion of the process. Then, update right fw on exact hw version . After completed, wait about 30 secondns, and make it off, wait, on again.
If not successfull, use swd programming . it is described blow
http://vedder.se/
Connecting a programmer/debugger to my custom STM32 PCBs