New to Vesc tool. Just had my xenith take dump after a capacitor fell off that lasted about 5 years. Brand new stromcore setup with the voyager 2 transmitter, (yes I switched the imput wires) first run about a half a mile frim the house the brakes went out and the ESC wouldn't turn on after. I couldn't get anything out of it into the vesc tool on my phone and then I downloaded the computer app and neither will connect. The company sent me a new stormcore 60d, everything went good setting up until the phone app proceeded a firmware update to adjust furthur settings. This locked out my voyager 2 transmitter no sending any signal. After following Jared from BKB's youtube video to navigate the app, I donwloaded the files from githubn, uploaded the lisp scripts, over a week and hours of trying to program, now I have another stormcore device that will not connect to the vcesc tool app. Not sure why the new firmware is causing so many problems and why It would automatically update if it does. But I can't get any help from anyone. I hope someone familiar with the system is on here. I thought vesc was the best but I got two paperweights that haven't ran a mile.