You are here

Home » Forums » General discussion

Could not read motor configuration during detection

2 posts / 0 new
Log in or register to post comments
Last post
Wed, 2023-08-02 17:17
#1
siegele1
Offline
Last seen: 1 year 4 months ago
Joined: 2023-06-01 14:40
Posts: 1
Could not read motor configuration during detection

Hello Guys,

I am trying to use 2 BLDC Hoverboard motors with my Vesk MK6.

As I am doing the FOC Wizard and Run detection, an error occurs and it says "Could not read motor confiuration".

Is anyone familiar with this issue?

Thanks a lot!

Top
Thu, 2023-08-03 08:23
electricfox
electricfox's picture
Offline
Last seen: 7 hours 8 min ago
VESC Original
Joined: 2019-01-01 17:11
Posts: 126

Are motor temperatursensor and hallsensors connected? Try without first. If it works, make sure motor temperature sensor type and values are correct.

Link to forum post: VESC help offered for private persons and companies
Website: www.electricfox.de

Top