You are here

Reconstruct detection control algorithm inside the tool

1 post / 0 new
kaanozgen
Offline
Last seen: 10 months 3 weeks ago
Joined: 2020-02-17 08:24
Posts: 7
Reconstruct detection control algorithm inside the tool

Hi there,

My motor runs well during auto detection phases (both FOC and BLDC). After that, the manual controls (D,I,RPM, etc.) don't get it close as smooth. In fact, it only runs at 21% Duty Cycle. Tried PPM input in any available option, still no chance.

I wonder if I can run the detection algorithms inside the tool. Maybe in the development area? Is there some documentation about that?

Eagerly looking to any ideas!

Thanks!