Good morning Boys, i already asked in general forum, but i didn t recive any information, maybe It was in a wrong section.
I changed the old esc with a new vesc board in mu ebike. The battery Is a 16s10p 26000mah.
So my problem Is that i don t have torque when i push the Throttle. The maximum velocity Is the same that i had with the old esc . The old esc was a 60v and 40 amps. The new esc Is 72v 130 amps in continuos .
The motor Is a 1300w continuos Power and 1800w peack Power 60v sensorless.
In vesc tool I tried with autodectection , i set medium motor and the vesc tool gives me 50 amps as max current , i think that this value Is right with the motor spec.
Now, when i push the Throttle the motor tries to start , and gives to me some punchs , but It seems to haven t the sufficent torque. Instead if i stand up the tyre , It turns without problem. Is It possible to increase the torque to return to the old acceleration? Thanks a lot