You are here

Home » Forums » VESC Tool

Bad detection problem

6 posts / 0 new
Log in or register to post comments
Last post
Fri, 2018-06-29 17:56
#1
baron456
Offline
Last seen: 5 years 3 weeks ago
Joined: 2018-05-12 23:31
Posts: 3
Bad detection problem

I'm experiencing problems after upgrading my firmware to 3.102 using the latest vesc tool version.

Originally I was on fw 2.18 without any problems with the old BLDC tool - tried to put the same setup in the new vesc tool but I get bad detection..

Top
Fri, 2018-06-29 18:24
Danny Bokma
Offline
Last seen: 10 months 2 weeks ago
VESC Original
Joined: 2017-05-24 12:11
Posts: 53

DID YOU UPLOAD THE FIRMWARE FOR THE CORRECT HARDWARE?

Top
Fri, 2018-06-29 20:06
(Reply to #2)
baron456
Offline
Last seen: 5 years 3 weeks ago
Joined: 2018-05-12 23:31
Posts: 3

Yes. For sure 

Top
Sat, 2018-06-30 14:18
baron456
Offline
Last seen: 5 years 3 weeks ago
Joined: 2018-05-12 23:31
Posts: 3

Anyone...?

Top
Sat, 2018-06-30 19:01
TechAUmNu
Offline
Last seen: 2 months 5 days ago
Joined: 2017-09-22 01:27
Posts: 575

I thought the latest firmware was 3.38. Make sure you get the latest version of vesc tool from this website.

 

Also a lot has changed in the last firmware. You need to run motor detection again for it to work properly.

Top
Fri, 2018-07-13 14:41
frank
Offline
Last seen: 3 weeks 3 days ago
VESC BronzeVESC FreeVESC GoldVESC OriginalVESC PlatinumVESC Silver
Joined: 2016-12-27 20:19
Posts: 847

FW 3.102  does not belong to the VESC-Tool! It belongs to Nico Ackermanns Fork of the VESC-Tool. It's compatible with VESC-Tool at all!

Please download VESC-Tool from this site, as TechAUmNu stated.

Frank

 

Top