You are here

Unanswered forum topics

Topic Forumsort ascending
Normal topic Maytech VESC keeps startup spinning slowly
by Snorreman on Mon, 2018-09-24 09:57
Third Party Hardware
Normal topic FAULT_CODE_DRV Motor not spinning
by Mightyorc on Sat, 2018-09-15 03:36
General discussion
Normal topic Maytech esc 5V rail reads 0.5v
by hhhhghg on Fri, 2018-09-14 13:23
Third Party Hardware
Normal topic Cut-out at >40A
by thewho on Thu, 2018-09-13 20:24
General discussion
Normal topic Prevent Wheel-slip by low-pass filtering duty cycle output
by AlexBenn on Thu, 2018-09-13 07:50
VESC Firmware
Normal topic Single shunt
by andreas on Wed, 2018-09-12 22:17
Feature Requests
Normal topic Vesc and Arduino Interface with ppm control????
by ruthvikchanda on Mon, 2018-09-10 12:01
General discussion
Normal topic Foc openloop soft start
by Alan oldguy on Fri, 2018-09-07 03:05
Feature Requests
Normal topic Move FAULT pin to GPIOD_PIN2
by CTSchorsch on Tue, 2018-09-04 10:13
VESC Firmware
Normal topic Ramping and idle control
by dougm on Sat, 2018-09-01 16:22
Feature Requests
Normal topic VESC Software Understanding
by shubhamt on Wed, 2018-08-22 15:40
General discussion
Normal topic Hub motor FOC detection.
by Roger Wolff on Tue, 2018-08-21 19:12
General discussion
Normal topic Raw encoder output from UART
by sprockmonty on Mon, 2018-08-13 16:45
Feature Requests
Normal topic servo input
by Roger Wolff on Tue, 2018-07-03 07:50
VESC Firmware
Normal topic can't communicate with arduino nrf
by m.juan on Mon, 2018-07-02 16:57
General discussion
Normal topic Vesc Tool cannot detect firmware
by MARK EVERITT on Sat, 2018-06-30 18:36
VESC Firmware
Normal topic Defining when Watt-hour / Amp-hour Data are rezeroed
by isabar on Sun, 2018-06-24 10:19
Feature Requests
Normal topic Problem after flash fw 3.38 detection faild dont spin
by kataklysm_9090 on Tue, 2018-06-19 22:48
VESC Firmware
Normal topic Setting the minimum ERPM in FOC mode?
by mathias on Sat, 2018-06-16 02:20
Feature Requests
Normal topic [SOLVED]Motors "blocking totally" when throttling, after running VESC setup.
by MaddiQ on Tue, 2018-06-12 21:01
General discussion

Pages

Subscribe to Unanswered forum topics