You are here

Unanswered forum topics

Topic Forumsort descending
Normal topic Problem report: VESC keeps running at full reverse throttle after PPM input returns to mid-stick
by chunkulator on Sun, 2019-08-11 00:34
VESC Firmware
Normal topic what do you guys think about this "curr_samp_volt "?
by jem on Thu, 2019-08-08 14:45
VESC Firmware
Normal topic How to set a jog speed using an encoder
by AK6302019 on Wed, 2019-08-07 15:42
General discussion
Normal topic "Throttle" help
by benha on Wed, 2019-08-07 05:58
General discussion
Normal topic Help setting up dual vesc via CANBUS
by Jaystro16 on Sun, 2019-08-04 01:39
VESC Firmware
Normal topic Can I re-use an old Galaxy S3 to run the VESC tool?
by Munkyheed on Fri, 2019-08-02 20:00
VESC Tool
Normal topic Programming Vesc 4.12 motor spin only in detection mode
by DanieleRA on Sun, 2019-07-28 16:29
VESC Original Hardware
Normal topic VESC with no working brake button
by tavsanist on Sat, 2019-07-27 02:40
General discussion
Normal topic Weird BLDC Current Waveform
by thepcman on Thu, 2019-07-25 10:38
General discussion
Normal topic Current loop resonance in higher ERPM under Current Mode
by ypl on Sat, 2019-07-20 09:34
General discussion
Normal topic Reassign status LED ports
by Filcas on Fri, 2019-07-19 17:17
VESC Firmware
Normal topic Serial Communication in Non-RT System
by Jack_Li on Fri, 2019-07-05 15:58
VESC Firmware
Normal topic How to Write Serial Communication Program Not Applicable to RTOS
by Jack_Li on Fri, 2019-07-05 06:55
General discussion
Normal topic step by step ebike thorttle setup
by sindre on Wed, 2019-07-03 17:59
General discussion
Normal topic dual VESC battery current
by chris_winkel on Tue, 2019-06-18 15:26
VESC Original Hardware
Normal topic Step/Dir signals
by wall0069 on Sun, 2019-06-09 16:06
General discussion
Normal topic Dual control loop with magnetic encoders
by wall0069 on Sun, 2019-06-02 05:39
Feature Requests
Normal topic UART write read arduino
by matiller on Sat, 2019-06-01 20:18
VESC Tool
Normal topic ADC Positive and Negative Ramping Time - not working
by Astropower on Tue, 2019-05-28 22:41
VESC Tool
Normal topic Fault: FAULT_CODE_HIGH_OFFSET_CURRENT_SENSOR_3 on VESC 6
by Jackl on Tue, 2019-05-28 14:48
VESC Original Hardware

Pages

Subscribe to Unanswered forum topics