|
Normal topic
|
Maytech VESC keeps startup spinning slowly
by Snorreman on Mon, 2018-09-24 09:57 |
Third Party Hardware |
|
Normal topic
|
FAULT_CODE_DRV Motor not spinning
by Mightyorc on Sat, 2018-09-15 03:36 |
General discussion |
|
Normal topic
|
Maytech esc 5V rail reads 0.5v
by hhhhghg on Fri, 2018-09-14 13:23 |
Third Party Hardware |
|
Normal topic
|
Cut-out at >40A
by thewho on Thu, 2018-09-13 20:24 |
General discussion |
|
Normal topic
|
Prevent Wheel-slip by low-pass filtering duty cycle output
by AlexBenn on Thu, 2018-09-13 07:50 |
VESC Firmware |
|
Normal topic
|
Single shunt
by andreas on Wed, 2018-09-12 22:17 |
Feature Requests |
|
Normal topic
|
Vesc and Arduino Interface with ppm control????
by ruthvikchanda on Mon, 2018-09-10 12:01 |
General discussion |
|
Normal topic
|
Foc openloop soft start
by Alan oldguy on Fri, 2018-09-07 03:05 |
Feature Requests |
|
Normal topic
|
Move FAULT pin to GPIOD_PIN2
by CTSchorsch on Tue, 2018-09-04 10:13 |
VESC Firmware |
|
Normal topic
|
Ramping and idle control
by dougm on Sat, 2018-09-01 16:22 |
Feature Requests |
|
Normal topic
|
VESC Software Understanding
by shubhamt on Wed, 2018-08-22 15:40 |
General discussion |
|
Normal topic
|
Hub motor FOC detection.
by Roger Wolff on Tue, 2018-08-21 19:12 |
General discussion |
|
Normal topic
|
Raw encoder output from UART
by sprockmonty on Mon, 2018-08-13 16:45 |
Feature Requests |
|
Normal topic
|
servo input
by Roger Wolff on Tue, 2018-07-03 07:50 |
VESC Firmware |
|
Normal topic
|
can't communicate with arduino nrf
by m.juan on Mon, 2018-07-02 16:57 |
General discussion |
|
Normal topic
|
Vesc Tool cannot detect firmware
by MARK EVERITT on Sat, 2018-06-30 18:36 |
VESC Firmware |
|
Normal topic
|
Defining when Watt-hour / Amp-hour Data are rezeroed
by isabar on Sun, 2018-06-24 10:19 |
Feature Requests |
|
Normal topic
|
Problem after flash fw 3.38 detection faild dont spin
by kataklysm_9090 on Tue, 2018-06-19 22:48 |
VESC Firmware |
|
Normal topic
|
Setting the minimum ERPM in FOC mode?
by mathias on Sat, 2018-06-16 02:20 |
Feature Requests |
|
Normal topic
|
[SOLVED]Motors "blocking totally" when throttling, after running VESC setup.
by MaddiQ on Tue, 2018-06-12 21:01 |
General discussion |
