|
Normal topic
|
Sensored BLDC mode confusion
by srinath on Wed, 2023-07-05 15:45 |
VESC Tool |
|
Normal topic
|
Settings
by aquamarin on Sat, 2023-07-01 16:11 |
General discussion |
|
Normal topic
|
Latched power switch on Trampa VESC 6 75A
by dversity on Wed, 2023-06-28 00:36 |
VESC Tool |
|
Normal topic
|
Motors spin during detection but then won't spin
by jsbenson on Tue, 2023-06-27 23:54 |
General discussion |
|
Normal topic
|
(Watchdog) - Resets with multipole engine.
by edilger on Mon, 2023-06-26 12:33 |
VESC Firmware |
|
Normal topic
|
Can someone verify this
by jsbenson on Mon, 2023-06-26 09:22 |
General discussion |
|
Normal topic
|
Torque Ripples with AC Servo Motor and Trampa VESC6 MKI
by Der6FingerJo on Mon, 2023-06-19 23:25 |
VESC Original Hardware |
|
Normal topic
|
Error code 6
by PatWhite32 on Mon, 2023-06-19 23:15 |
General discussion |
|
Normal topic
|
RPM and torque control modes
by srinath on Fri, 2023-06-16 10:52 |
General discussion |
|
Normal topic
|
Not sure if parameter update in VESC tool works
by srinath on Thu, 2023-06-08 11:29 |
VESC Tool |
|
Normal topic
|
No load FOC stops when full FWD throttle.
by toboli on Mon, 2023-06-05 18:41 |
General discussion |
|
Normal topic
|
VESC appears to loose sync when increasing throttle
by srinath on Sun, 2023-06-04 04:11 |
General discussion |
|
Normal topic
|
Bluemind 80V/450A and 100V/550A
by qdxiatao on Fri, 2023-06-02 11:14 |
General discussion |
|
Normal topic
|
Issue with Vesc Tool: MPU6050 IMU Not Detected After Power Cycling
by Lennart Duijn on Thu, 2023-06-01 21:54 |
VESC Tool |
|
Normal topic
|
Comm conflict when connecting external imu?
by Lennart Duijn on Wed, 2023-05-31 22:53 |
VESC Tool |
|
Normal topic
|
Vesc 75100
by Matteo Christian on Wed, 2023-05-31 13:32 |
General discussion |
|
Normal topic
|
Help Please 🥺
by Jou2023 on Sun, 2023-05-28 17:58 |
General discussion |
|
Normal topic
|
Observer Gain? What is it and what does it affect?
by kianK on Fri, 2023-05-26 10:53 |
VESC Firmware |
|
Normal topic
|
Motor Detection Error
by Matish on Tue, 2023-05-23 17:37 |
VESC Firmware |
|
Normal topic
|
"Allow Breaking" set to "TRUE" when "Backup COnfigurations (Including CAN)
by bayetan on Mon, 2023-05-22 05:33 |
VESC Tool |
